More jobs:
Process Engineer
Job Description & How to Apply Below
Job Description:
Process Engineer /Process Design EngineerRequired Experience:
Process design and engineering experience of 8 to 12+ years in Oil & Gas projects upstream projects, pipeline projects covering design, conceptual engineering, FEED, Detailed engineering.
The candidate should have experience in preparing the following deliverables for Basic Engineering, FEED, or EPC projects with a reputed international EPC consultant.
- Design Basis
- Licensor Technology Evaluation
- PFD and P&n and or review for Urea Plant
- HMB
- Process data sheets, Equipment list, Line list, Load list, Tie-In list, Fluid list,
- PSV Relief load estimation, PSV sizig
- Flare sizing, KOD sizing
- Pump sizing
- Compressor Calculations, Anti surge design, settle out calculations etc
- Steam generation and sizing calculations
- Design of Separators, columns, Heat Exchangers, tanks
- Hydraulic calculations, PSV sizing, Control valve sizing calculations
- Interfacing with Piping, Mechanical Instrument engineers, Commissioning Engineers as required during the EPC stages
- 3D Model Review
- vendor offer reviews
- Experience across conceptual design, FEED, and detailed engineering phases.
- Operation experience is not preferred.
- Experience with process simulation and engineering software such as HYSYS, PROMAX, Flare network analysis tools, and HTRI.
- Strong understanding of process design, sizing, and optimization techniques.
- Ability to critically review calculations and propose practical engineering solutions.
- Strong technical documentation and report-writing skills.
- Fluent in spoken and written English.
- B tech Chemical Engineering / MTech Chemical Engineering
- 75% Marks in engineering are mandatory
Key Responsibilities
- Perform process design review and verification across conceptual, FEED, and detailed engineering stages.
- Prepare and review process design basis, philosophies, and engineering calculations.
- Review and verify Process Flow Diagrams (PFDs), Piping & Instrumentation Diagrams (P&IDs), and Heat & Material Balances (HMB).
- Review process datasheets, equipment lists, line lists, tie-in lists, fluid and load lists.
- Perform and review PSV relief load estimation and PSV sizing calculations.
- Review flare system calculations, knockout drum sizing, and associated hydraulics.
- Review pump, compressor, and rotating equipment process calculations including anti-surge and settle-out analyses.
- Review design of separators, columns, heat exchangers, tanks, and other process equipment.
- Perform hydraulic calculations and control valve sizing reviews.
- Interface with piping, mechanical, electrical, and instrumentation disciplines during EPC execution.
- Participate in 3D model reviews and vendor technical document reviews.
- Prepare and review technical reports, calculation notes, and design review comments.
- Ensure compliance with applicable international codes, standards, and project procedures.
- Site Visit :
The candidate may be required to occasionally visit project sites to conduct audits or verification activities.
Location:
Abu Dhabi, UAE
To View & Apply for jobs on this site that accept applications from your location or country, tap the button below to make a Search.
(If this job is in fact in your jurisdiction, then you may be using a Proxy or VPN to access this site, and to progress further, you should change your connectivity to another mobile device or PC).
(If this job is in fact in your jurisdiction, then you may be using a Proxy or VPN to access this site, and to progress further, you should change your connectivity to another mobile device or PC).
Search for further Jobs Here:
×