Crane & Rigging Specialist

The Crane & Rigging Specialist is Fermi America's owner-side authority for every crane and rigging operation  role plans, reviews and oversees lifts so heavy equipment is set safely, on schedule and without damage.

Key lifts include relocated GE Frame 6B gas turbine and generator packages, Siemens SGT-800 units, HRSG modules, step-up and substation transformers, and large tanks and piping spools. The specialist works with EPC contractors, crane rental firms and OEM field representatives, and holds stop-work authority over any unsafe lift.

• Review and approve lift plans for standard and critical lifts per the site Lifting & Rigging Program.
• Classify critical lifts: over 75% of rated chart capacity, multi-crane or tandem picks, lifts over occupied or energized areas, personnel platforms, and high-value OEM equipment.
• Verify load weights, center of gravity, rigging configurations, ground bearing pressure and crane mat design against OEM data and engineered drawings.
• Coordinate with engineering on lifting lugs, spreader bars, and temporary works that need PE-stamped design.

• Conduct periodic audits of pre-lift meetings and Job Hazard Analyses; sign off lift permits.
• Observe critical lifts in person and monitor wind, weather and exclusion zones.
• Exercise stop-work authority when conditions, equipment or personnel do not meet plan.

• Verify frequent and periodic crane inspections per OSHA 29 CFR  and ASME B30.
• Audit annual third-party crane certifications, load charts, and operator aids.
• Audit site rigging gear inspections and the color-code and tagging program; remove defective gear from service.

• Verify operator certification (NCCCO or equivalent), qualified rigger and qualified signal person status before work starts.
• Deliver or coordinate rigging and signal person training for craft and contractor crews.

• Review contractor lifting plans and crane mobilization submittals.
• Support procurement on crane rental scope, heavy-haul and set contracts, and rigging equipment purchases.
• Coordinate lift windows with P6 schedule, OEM field reps, laydown and heavy-haul logistics.

• Maintain lift plans, inspection records and certifications in Aconex.
• Investigate and report near-misses and incidents involving cranes or rigging; track corrective actions.
• Report weekly on lifts completed, upcoming critical lifts and crane fleet status.

• 10+ years in crane operations, rigging or lift planning; at least 5 years on heavy industrial, power generation or refinery construction.
• Current NCCCO Rigger Level II and NCCCO Signal person certifications.
• Demonstrated experience planning and directing critical lifts above 100 tons, including tandem and multi-crane picks.
• Working knowledge of OSHA 29 CFR 1926 Subpart CC, ASME B30.5 (mobile cranes), B30.9 (slings), B30.20 (below-the-hook devices), B30.26 (rigging hardware), and ASME P30.1 (lift planning).
• Ability to read load charts, engineering drawings, OEM lifting instructions and ground bearing studies.
• Proficiency with lift planning software (3D Lift Plan, Liebherr LICCON, Kran Xpert or equivalent).
• OSHA 30-Hour Construction.
• Valid driver's license; ability to pass pre-employment drug screen and background check.

• NCCCO Lift Director and/or Mobile Crane Operator (TLL/TSS/LBC) certification.
• Experience setting gas turbines, generators, HRSG modules or large power transformers, including OEM-witnessed sets.
• Heavy-haul, jacking-and-skidding, gantry and SPMT experience.
• Owner's representative or third-party oversight experience on…