Welder - Second Shift

** Standard

Job Description *
* ** What You Will Be Doing*
* As a Welder, your responsibilities will include, but are not limited to:

+ Layout, fit up and all welding and related fabrication processes on low complexity aluminum and/or steel/stainless steel weldments/parts

+ Receives tacked medium complexity aluminum or steel/stainless steel weldments from senior welders to complete full weld-out and straightening operations to tight tolerances and in accordance with manufacturing instructions

+ Cleans and prepares parts for welding by wire brushing, abrasive shot blast, and aqueous or solvent cleaning

+ Completes straightening operations on parts and assemblies other than weldments

+ Collaborative Welding Robot operation including:

+ Loads fixture tooling with subassembly components for tack-up and full weld-out

+ Verifies accurate Tool Center Point (TCP) and calibration utilizing both laser TCP tool and manual methods prior to production operations

+ Runs pre-programmed welding operations verifying parameters are producing good bead profile and fusion in accordance with inspection criteria

+ Communicates problems/errors during operation to engineering/supervision for the purpose of corrective action

+ Checks/corrects sub-assemblies for flatness/straightness following Cobot operations

+ Grinding, straightening, and metal finishing to meet final product finish requirements

+ Utilizes jigs, fixtures, table setups, clamps and angle plates precisely as specified by work instructions and/or group leader/supervision direction to produce the correct shapes and dimensions

+ Sets up, qualifies and runs spot welding equipment in accordance with specified procedures

+ Interprets CAD data, prints and sketches with regard to fabrication and follows written and/or verbal instructions

+ Sets up and maintains welding equipment

+ Follows welding sequences precisely as specified by work instructions and/or group leader/supervision to minimize heat distortion and straightening requirements

+ Maintains workstation/cell in organized manner and in compliance with any applicable safety standards

+ Works in time-critical situations in a dynamic, team-oriented environment where programs, setups, and tooling are constantly changing and interacts effectively with associates & management as priorities shift

+ Receives and provides cross-training for other tasks related to department functions and procedures

+ Recommends and executes changes to achieve process improvements and/or cycle time reductions

+ Uses precision measuring tools such as vernier caliper, micrometers, and various welding inspection tools

+ Other job-related duties as required by management

+ Physical condition allowing:

+ Lifting 50 pounds

+ Standing, sitting, bending, walking, 10+ hours per day

+ Personal protective equipment including steel-toed shoes, safety glasses, hearing protection, and wearing a respirator when required

+ Works with others and cross-shift with others on the same work

+ Employs various hand tools such as hammers, chisels, squares, and straight edges

+ Wash, mask, shot/abrasive blast, and apply metal flame spray to parts and weldments per established manufacturing instructions

+ Adheres to safety guidelines and the correct procedures for performing tasks to prevent personal injury or damage to product and/or equipment

** Further Information About This Opportunity*
* This position is in Archbald. Discover more about our Archbald, Pennsylvania location:  

MUST BE A U.S. CITIZEN - This position is located at a facility that requires special access.

** Basic Qualifications*
* + Ability to qualify and retain qualifications necessary of the welds being performed

+ Experience on aluminum or steel/stainless steel parts and assemblies in accordance with supplied…