Maintenance - Athens, GA

Overview

This position will use their skillset in the installation, preventive maintenance, and repair of ALL manufacturing equipment while considering the values and goals of Power Partners.

• Understand and carry out detailed written/verbal instructions regarding the installation, preventive maintenance, and repair of ALL manufacturing equipment.
• Complete training to ensure safe and proper operation of tools, equipment, and installation of manufacturing equipment.
• Repeatedly lift/move material that is 50+ lbs. with or without assistance from lifting devices and/or co-workers.
• Ensure all equipment is functioning at optimum levels by performing short-term repairs and long-term improvements as specified on work orders and preventative maintenance schedules.
• Follow all safety policies and procedures.

• Must be able to communicate and understand instructions.
• Organizational skills and attention to detail is necessary.
• Add, subtract, multiply, and divide in all units of measure.
• Must be able to demonstrate proper lifting techniques.
• Must be able to grasp, reach, and handle objects, tools, and materials.
• Use measuring devices and hand/power tools.
• Operate overhead hoists and lift assist equipment.
• Must be able to lift, push 75+, and pull up to 60 lbs.
• Frequent standing and walking is necessary;
  Occasional sitting, stooping, reaching, or kneeling.
• 20/40 vision is required with or without corrective lenses, and normal peripheral vision no less than 70, depth perception, and ability to adjust focus.
• Must comply with all plant safety policies and procedures and any special department safety rules.
• Must be able to wear all required PPE including safety-toed shoes, safety glasses, cut-resistant gloves, and hearing protection.
• Working knowledge in mechanical, electrical, hydraulic, & pneumatic troubleshooting and repairs, including gearbox and hydraulic pump repairs and replacements, drive belts and roller conveyor repairs and replacements, proximity switches and sensor replacements.
• Can weld using two of three processes (Tig, Mig, or Stick).
• Basic knowledge in PLC function.
• Install equipment, level and plumb air lines and conduit.
• Ability to complete position-specific assignments with minimal to no supervision in mechanical & electrical processes.
• Demonstrate high level of workmanship, integrity, and efficiency with all work performed.

• Entry level

• Full-time

• Manufacturing and Production

• Manufacturing