Manufacturing Engineer

World Class Defence Organisation based in Bolton is currently looking to recruit a Manufacturing Engineer. The department are looking for candidates with skills in the following:
Verification & validation, design modifications, commissioning, FMEAs, configuration control, sub-assembly manufacturing.

• Rate:£35.00 per hour
• Location:
  
  Bolton
• Contract:
  
  37 Hours per week
• Overtime:
  Hours worked over 37 hours per week will be calculated at ‘time and a quarter’
• Duration: 12 Months (initially and then ongoing and long-term thereafter)
• IR35 status:
  Inside IR35 (Umbrella)

As a Manufacturing Engineer within the unit & missile assembly manufacturing facility your focus will be to ensure that our products are built efficiently and to budget. A key member of the Manufacturing Engineering team, you will carry out activities in support of multi-project manufacturing.

• Compilation and update of Manufacturing Instructions.
• Design, Commissioning and proving of associated tooling.
• Support the industrial validation process through the use of FMEA’s, FAI’s etc.
• Resolution of technical problems that may arise during the manufacturing process.
• Route card changes as a result or rework activities.
• Management of Configuration Control by the embodiment of Design Modifications into the Manufacturing Instructions.
• Support to the Non Conformance Process using SAP.

• Verification & validation
• Design modifications
• COMMISSIONING
• FMEA’s
• Configuration control
• Sub-assembly manufacturing
• Industrial Validation through the use of FMEA’s, translating design requirements, interpret Design Drawings with a view to producing Manufacturing Build Instructions. Management of Configuration control by the embodiment of Design Modifications,
• Have the ability to interpret Design Drawings with a view to producing Manufacturing Build Instructions for both Skilled and Semi-Skilled operators.
• Have experience of Electronic Sub Assembly manufacture through to System level builds.
• Have experience and knowledge of the assembly process for small/miniature Electro-Mechanical Actuation Systems.
• Must be able to work within and contribute to a team environment.
• Recognise and understand customer requirements, and respond to them.

• Electrical or Mechanical Engineering / Manufacturing Apprenticeship (Advanced Level or L3 Standard)
  AND
• Electrical or Mechanical Engineering / Manufacturing Level 4 academic qualification (HNC, diploma, etc.)AND
• Electrical or Mechanical Engineering / Manufacturing Level 3 vocational qualification (NVQ)
  * Not required if a L3 apprenticeship standard has been achieved OR
• Degree in a relevant Engineering subject