Principal RF Engineer

Our client is a fast-growing UK engineering business developing advanced RF, sensing and communications technology for demanding operational environments. Based in Bristol, the role operates on a hybrid basis with a minimum of 3 days per week onsite. Candidates must also be eligible for UK SC clearance.
The role
As a Principal RF Engineer, you will take ownership of RF and mixed-signal hardware from initial architecture through schematic design, PCB implementation, bring-up and validation.
You will work across the full RF signal chain, including antenna interfaces, amplification, filtering, frequency conversion, signal conditioning and high-speed ADC/DAC integration.
The Principal RF Engineer will also work closely with FPGA, embedded software and signal-processing engineers, ensuring the hardware delivers the required system-level performance.
Typical work will include:
RF front-end and signal-chain design
Mixed-signal hardware incorporating high-speed ADCs and DACs
Multi-layer RF PCB and schematic design
RF component selection and integration
Hardware bring-up, debugging and optimisation
RF performance measurement using VNAs, spectrum analysers, signal generators and oscilloscopes
Integration with FPGA and SDR platforms
What they are looking for
Our client is looking for an experienced RF engineer who has designed complete RF or mixed-signal boards rather than working solely at system or simulation level.
You should have strong experience with:
RF analogue hardware and signal-chain design
Mixers, amplifiers, filters, oscillators and gain stages
High-speed ADC/DAC integration
RF and mixed-signal PCB design using Altium, KiCad or similar
RF layout, impedance control, grounding, isolation and signal integrity
Hardware bring-up and laboratory debugging
RF performance metrics including gain, noise figure, bandwidth and dynamic range

Experience with SDR, FPGA/Zynq platforms, sensing, electronic warfare, communications or low-SWaP systems would be useful, but is not essential.
Why consider it?
This is a genuinely hands-on Principal RF Engineer position with significant technical ownership.
You will be working on complex RF hardware that needs to operate reliably outside controlled laboratory environments, while remaining close to the design, build and test work.
The company has strong engineering and manufacturing capability in Bristol, with RF, FPGA, embedded and signal-processing engineers working closely together.
The role is hybrid, with a minimum of 3 days per week onsite in Bristol, and candidates must be eligible for UK SC clearance.
Reach out to Zac Taylor at IC Resources for more information.