Plating - Weekend Shift - Eligible

Plating
- Weekend Shift - 90 Day Increase Eligible We use cookies to offer you a better browsing experience, analyze site traffic, and personalize content. Read about how we use cookies and how you can control them by visiting our Cookie Settings page. If you continue to use this site, you consent to our use of cookies.### Plating
- Weekend Shift - 90 Day Increase Eligible Apply:
Denver, CO:
Full time:
Posted Today:
R18056

TTM Technologies, Inc. – Publicly Traded US Company, NASDAQ (TTMI) – Top-5 Global Printed Circuit Board Manufacturer##
** About TTM
** TTM Technologies, Inc. is a leading global manufacturer of technology products, including mission systems, radio frequency (“RF”) components, RF microwave/microelectronic assemblies, and technologically advanced printed circuit boards (“PCB”s). TTM stands for time-to-market, representing how TTM's time-critical, one-stop design, engineering and manufacturing services enable customers to reduce the time required to develop new products and bring them to market.

Additional information can be found .comThe Inner Layer Wet Process Operator uses wet chemistry to etch circuit images and apply oxide to panels.  Operators develop resist from layers, etch to remove copper that is not protected by resist, and strip off resist that was left from develop and etch cycles to expose circuit.  Process panels through developer to remove excess resist on all unexposed areas of panel.

Principal Duties and Responsibilities:

* Check ph to ensure it remains within established limits.
* Run break test to determine conveyor speed for developing.
* Check developing solution for proper concentration as specified by MPP.
* The resist strip process is the removal of photo resist exposing the copper circuits.
* Monitor and maintain proper solution levels on all rinse sumps.
* Change solutions per tank maintenance.
* Verify solution temperatures.
* Ability to process first article panel.
* Monitor to insure uniform and constant flow of work through appropriate resist stripper.
* Follow all preventive maintenance schedules.
* Follow all requirements for waste treatment.
* Inspect panels for defects.
* Cupric etching is a process whereby exposed copper is dissolved into a cupric based etchant.
* Process panels per inner layer MPP:
* Maintain automatic chemical feed and bleed systems.
* Monitor and maintain proper solution levels on all rinse sumps.
* Change solutions per tank maintenance or preventive maintenance.
* Verify etchant temperatures.
* Monitor etchant specific gravity.
* Run spray nozzle test and etch break test daily.
* Process first article panels.
* Measure spacing and line width with microscope.
* Set and monitor conveyor speed depending on copper thickness.
* Monitor process to insure uniform and constant flow of work through etcher.
* Follow all preventive maintenance schedules.
* Follow all requirements for waste treatment.
* Inspect panels for defects.
* Perform other duties as assigned.

Job

Knowledge, Skills and Abilities:

* Functional English skills (reading, writing, speaking)
* Attention to detail
* Adherence to all safety requirements of the position

Training Requirements:
* As required to run process according to Unicircuit Training guidelines
* The employee is responsible to follow all RCRA standards as outlined by the certification that he or she has been trained to at all times. The health and safety regulations encompass the cleanliness of the area that he or she will be working as a result.
* May handle hazardous waste as outlined in departmental work instructions.  The following RCRA training is required on initial hire and on an annual basis thereafter
* Introduction to RCRA, Properties of Facility Waste, Waste Minimization Accumulation, Container Management, and Emergency…