Model Shop; 2nd Shift

Eaton’s AER FMC Fuel Motion Control Systems division is currently seeking a Model Shop (2nd Shift). The hourly rate for this position is $37.41 + $1.00 shift differential per hour. The hours for this shift are 12:00 pm - 3:30 pm. Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations.

The Fuel and Motion Control Systems Division of Eaton’s Aerospace Group has an opening for a Certified Pre‑Production. This position is based in Euclid, OH. The Euclid facility has approximately 300 employees and is a leader in the design, development, manufacture and delivery of Aerospace Fuel Pumping components, systems and services to the global aftermarket and OEM markets.

• Following engineering prints, specifications, and routing sheets perform a variety of manufacturing, machining, fitting, assembly, and set up operations to plan and develop an array of tools, fixtures, and inspection equipment and/or repair components or equipment.
• Perform visual and dimensional inspections and maintain accurate documentation on a variety of parts in accordance with ANSI Y14-5 and the certified operator program.
• Assistance may be given to other operators on proper operational procedures.

• Plan, develop and manufacture a variety of equipment such as tools, jigs, fixtures, master dies, molds, gauges, inspection equipment, etc., used to manufacture and/or repair components or equipment.
• Set up and operate machining and grinding equipment, and perform layout, fitting, assembly, and manufacturing operations including milling, drilling, turning, polishing, etc.
• Use existing, or develop new methods, processes, and equipment to plan and execute manufacturing and/or repair operations on equipment and components.
• May on occasion be required to develop, set up and operate prototype, sample, or experimental procedures or production lots to test newly developed production methods of tooling.
• Use a full range of hand and power tools, as well as a variety of measuring devices equipment to perform job duties and check progress and quality of work, including under black light.
• Work in conjunction with the Engineering Department to plan, develop and improve production and repair processes, parts, and equipment.
• Follow engineering prints, specifications, and/or routing sheets, in performing all planning, development, manufacturing, and repair operations, but modify and revise such prescribed procedures as required.
• Perform necessary preparatory work which involves layout. Make all necessary set ups which may involve standard or improvised holding devices. Select, install, and dress abrasive wheels most suitable for the phase of work being ground such as contours, radii, angles, etc. Interpret prints of a complex nature and layout sequence of work in most efficient manner possible. Establish proper angular table settings to perform manual forming operations on work requiring the grinding or compound radii and angles.
• Work with engineering to make or modify tooling through sketches or verbal instructions.
• Occasionally do brazing to affix inserts to tool shanks.
• Review tool room supplies, such as tooling, build materials.
• Maintain accurate lot control (QCP 6.0) traceability, record keeping, logbook entries, NCR’s (QCP 11.0) and associated documentation.
• Perform minor machine maintenance.
• Maintain clean equipment and work area.
• Move material within the cell.
• Perform necessary part marking.

• High school diploma or GED from an accredited institution.
• Must reside within a 50‑mile radius of work location; no relocation benefit is provided.
• This position requires use of information or access to hardware which is subject to the International Traffic in Arms Regulations (ITAR). All applicants must be U.S. persons within the meaning of ITAR. ITAR defines a U.S. person as a U.S. Citizen, U.S. Permanent Resident (i.e. 'Green Card Holder'), Political Asylee, or Refugee.
• Minimum of 10 years full‑time setup and operation of various Machining Equipment including Lathes, Grinders and Mills. Including 4 years Setup and Operation of CNC equipment 3‑6 Axis; 10…