Network Administrator
-
IT/Tech
Job Description & How to Apply Below
- 401(k)
- 401(k) matching
- Dental insurance
- Health insurance
- Paid time off
- Profit sharing
- Tuition assistance
- Vision insurance
Sarela Tech is seeking a Sr. Network Engineer to support large-scale operations on a large, high-profile DOD contract. The I3TS program provides enterprise-wide IT support to enable DTRA’s Information Management & Technology Directorate (ITD) to consolidate, modernize, and continuously innovate the delivery of IT services and mission capabilities to DTRA’s internal and external mission partners operating in CONUS and OCONUS locations.
The Sr. Network Engineer/Architect will support the current infrastructure and new, modernized, updated, and upgraded capabilities for DTRA. This role will be responsible for tech requirements definition, feasibility studies, pilot projects and implementation plans, as well as diagnosing and troubleshooting outages, monitoring networks, infrastructure and systems, and providing proactive mitigation strategies.
- Lead and coordinate Tier I–III network operations engineering personnel to ensure network troubleshooting efforts are effectively built.
- Oversee real-time monitoring of global enterprise networks using DoD-approved tools (e.g., Solar Winds, Net Ops, Splunk, ACAS).
- Develop and enforce operational procedures, incident response workflows, and escalation protocols.
- Act as the senior technical point of contact for major outages, network events, or cybersecurity incidents.
- Interface with mission partners, DISA, Joint Forces, and Combatant Commands on network status, issues, and operational impacts.
- Ensure all network changes follow configuration management (CM) and DoD Change Advisory Board (CAB) procedures.
- Prepare and deliver operational briefs, after-action reports (AARs), and executive summaries to senior leadership.
- Develop and coordinate the network operations team that
- Plan and design secure network solutions to consolidate connectivity services under an enterprise service.
- Design secure wide area connectivity inclusive of underlay, overlay, and COI transport design that supports performance, quality of service, security, and mission requirements.
- Provide secure access solutions leveraging wired and wireless technologies, integrating standards, use cases/scenarios, and developing associated implementation and transition plans.
- Integrate capacity planning and scaling of network and security stack environments into the overall design of solutions.
- Collect, investigate, and identify network optimization strategies and techniques to meet capacity and performance standards.
- Identify legacy service paths (i.e. dataflow, firewall rulesets, and ACLs) and develop strategies and designs for the to-be enterprise service capability to meet requirements while balancing security, sustainability, and maintainability.
- Support development of IP addressing schemes across IPv4 and IPv6 networks.
- Work with information assurance teams to ensure compliance with DoW standards to assist with providing accreditation artifacts.
- Minimum of a Bachelor’s degree in Science, Technology, Engineering, and Math (preferred) with 8-12 years' experience or Master's degree with 6-10 years of experience (additional years of directly applicable experience may be accepted in lieu of a degree).
- Require network certification that meets or exceeds a CCNA (comparable vendor certification accepted upon review).
- Require active DoD IAT Level II (i.e., Security+) certification or equivalent prior to start.
- Must possess an active DoD Top Secret at time of consideration.
- Experience documenting logical or physical designs using drawing tools (e.g., Visio, PowerPoint, Gliffy, Cameo, Magic Draw) to depict systems, subsystems, interfaces,…
(If this job is in fact in your jurisdiction, then you may be using a Proxy or VPN to access this site, and to progress further, you should change your connectivity to another mobile device or PC).
View / Apply for Jobs
Matching My Jurisdiction