Electronics Technician, Maintenance Ii
-
Trades / Skilled Labor
Job Description & How to Apply Below
Share this job as a link in your status update to Linked In.
Job Title
ELECTRONICS TECHNICIAN, MAINTENANCE II
# of Hires Needed
1
Security Clearance Required
Secret
Work Location
Eglin Air Force Base, FL
Job Type
Full-time
Exemption Type
Non-Exempt
Education
Vocational / Trade School / Military Education
Experienced (Non-Manager)
Category
Hourly/Annual Rate
36.92
Job Description
ELECTRONICS TECHNICIAN, MAINTENANCE II Mission Department Open Position Request Number: R-120-26 GRADE:Non-Exempt;
Regular, Full-Time
LOCATION:
Radar Test Site A-20, Mary Esther / Eglin AFB, FL – On Site POSTING DATE:
Internal Applicants (11/10/2026) / External Applicants (11/16/2026)
ESSENTIAL FUNCTIONS:
The Electronics Technician Maintenance II Receives work assignments from the supervisor. Primary duties are inspection, maintenance, modification, repair, and operation of the RIR
980s and FPS-16 Radar systems at A20 and at C10 test site, 320W Weibel Radar, and the Data equipment utilizing RICS software. Helping out on the Flight Termination Equipment at A-3 test site as required. Will be subject to cross-utilization in areas such as (but not limited to) ground-to-air radios, microwave communications, and telemetry data collection. Uses applicable test equipment such as multi-meters, oscilloscopes, spectrum analyzers, signal generators, spectrum analyzers, power meters, frequency counters, etc.
in the course of inspection, maintenance, troubleshooting, and repair of electronic systems with little oversight from other technicians. Will be required to climb ladders, towers, platforms, etc. to facilitate maintenance and repair of antennas and related electronic or mechanical systems.
The Electronics Technician Maintenance II applies basic and some advanced technical knowledge to solve routine problems by interpreting manufacturers’ manuals or similar documents. Work requires familiarity with the interrelationships of circuits and judgment in planning work sequence, in selecting tools, testing instruments, and is reviewed for compliance with accepted practices. This technician works under immediate supervision and achieves technical guidance, as required, from supervisor or higher-level technician.
This technician may assist higher-level technicians in accomplishing modifications as well as identifying problems requiring further investigation. May be required to assist senior level technicians in performing software adaptations and computer problem solving and repair or perform minor actions without higher-level assistance. May be required to provide guidance, training, and functional supervision to lower-level technicians. Required to perform with limited instructions or supervision.
Must possess a general knowledge of electronic component characteristics to aid in the selection of replacement components and devices. Knowledge of other trades such as the mechanical skills necessary to repair and modify servo systems, pedestal-drive systems, waveguide installations, and optics associated with laser and camera systems a plus. Must be thoroughly familiar with the operation of test instruments such as oscilloscopes, signal generators, spectrum analyzers, frequency measuring equipment, and other related measurement instruments.
- Receives work assignments from the supervisor. Primary duties are inspection, maintenance, modification, repair, and operation of Advanced Command Destruct System (ACDS) at A-3 test site and on occasions work on Radar systems at C-10/A-20 test sites.
- Data equipment utilizing RICS software, and Flight Termination Equipment at A-3 test site.
- Will be subject to cross-utilization in areas such as (but not limited to) ground-to-air radios, microwave communications, and telemetry data collection.
- Uses applicable test equipment such as multi-meters, oscilloscopes, spectrum analyzers, signal generators, spectrum analyzers, power meters, frequency counters, etc. in the course of inspection, maintenance, troubleshooting, and repair of electronic systems with little oversight from other technicians.
Job Requirements
OTHER DUTIES:Other functions include assisting in the orientation and training of other technicians at this level when directed by the supervisor. Will perform general housekeeping and other job-related tasks. May be required to handle hazardous material/hazardous waste. Some mission support overtime occurring before and/or after these hours may be required.
EDUCATION/EXPERIENCE…(If this job is in fact in your jurisdiction, then you may be using a Proxy or VPN to access this site, and to progress further, you should change your connectivity to another mobile device or PC).
View / Apply for Jobs
Matching My Jurisdiction