Sheet Metal Mechanic

Location:

Jacksonville, FL | Salary: $44,720.00–$78,520.00

• Prepare, fabricate and install sheet metal duct to specifications.
• Install hangers, supports, according to plans or shop drawings and applicable specifications.
• Hoist loads using slings, chains, shackles, hooks, cables, and other rigging equipment.
• Read and interpret project drawings and specifications.
• Lay out work including hanger locations, duct routes, and equipment pads/curbs.
• Install rectangular, spiral, and duct board with occasional insulated duct work.
• Identify safety risks and the precautions required to eliminate those risks.
• Occasionally work in an attic or underneath a structure in a crawl space.

• A valid driver’s license.
• Clean driving record.
• 5 years of experience with commercial sheet metal duct installation.
• Ability to read prints and construction drawings.
• Ability to work independently with minimal supervision.
• Effective communication skills.
• Physical activities of walking and lifting weights of 50 pounds or more are required, standing, balancing, climbing stairs, ladders, and scissor/boom lifts in accordance with safety policies.
• Trade knowledge of all joint methods for sheet metal duct including but not limited to slip and drive, TDC/F, and Duct Mate.
• Must be capable of working outside in the elements including but not limited to the heat, cold, rain, and wind.
• OSHA 10-hour card.
• Will be required to wear personal protective equipment (PPE) including but not limited to hard hats, safety glasses/goggles, safety vests, gloves and steel-toe boots.

• Dental insurance.
• Health insurance.
• Paid time off.
• Vision insurance.

Overtime available.