Member of Technical Staff, Frontier AI & Robotics
-
Automotive
Job Description & How to Apply Below
Job : | Services LLC
Join Amazon's Frontier AI & Robotics (FAR) team and play a hands-on, technically deep role in bringing the next generation of intelligent robotic systems to life. As a Robotics Lab & Support Engineer, you'll own the full lifecycle of robot prototypes — precision assembly, wiring and electrical integration, system bring-up, calibration, and acceptance testing — taking robots from a kit of parts to a validated, working system.
You'll also serve as the first line of defense when prototypes break, triaging failures across mechanical, electrical, and software domains, performing root-cause analysis, and driving corrective actions back into designs and processes. We're looking for a resourceful engineer with real robotics experience who is as comfortable reading schematics and torquing fasteners as they are reading logs, running debuggers, and writing scripts to isolate faults.
job responsibilities
- Assemble electromechanical robotic systems and subsystems (actuators, gearboxes, sensors, vision systems, wiring harnesses, PCBAs) for early prototypes using mechanical drawings and schematics. Help create work instructions and assembly procedures.
- Kit parts against the BOM, stage hardware and fixtures, set up assembly jigs and alignment rigs, and support build cycles from kit prep through final system checkout.
- Build first articles from prototype kits, provide engineering with actionable build feedback (DFx), and execute rework and engineering change orders (ECOs) as designs iterate.
- Fabricate, route, and terminate wiring harnesses to documented pinouts with proper strain relief, bend radius management, and cable routing for moving assemblies.
- Perform pre-power-on electrical verification (continuity, pinout, insulation, polarity) and board-level integration under ESD discipline.
- Bring up newly built assemblies; verify actuator, sensor, and control-loop function; perform sensor calibration; and run acceptance testing and performance characterization using standard and custom test equipment.
- Use git and the Linux command line to install, configure, and run test, calibration, and diagnostic software on robot platforms; track software versions and configurations across the fleet.
- Serve as the primary first responder when robot prototypes fail - systematically debug across mechanical, electrical, firmware, and software domains, reproduce faults, and perform structured root-cause analysis.
- Document triage findings in clear, actionable reports; collaborate with ME, EE, controls, and software engineers to drive corrective actions into designs, firmware, and work instructions.
- Track recurring failure modes and advocate for design or process changes to eliminate them.
- Maintain build records, travelers, inspection checklists, and non-conformance reports (NCRs) ensuring full traceability; redline and improve work instructions with each build.
- Keep the lab safe, organized, and ESD-compliant; track tooling, consumables, and inventory; follow all safety protocols for high-voltage electronics and heavy robotic assemblies.
- Drive continuous improvement by developing SOPs, assembly aids, debug guides, and training materials; mentor junior technicians on assembly, test, and troubleshooting best practices.
- On-site lab role; standing, bench work, and hands-on assembly for extended periods, including work in awkward positions and tight spaces.
- Fine motor precision and close-vision work with small fasteners, connectors, and board-level components.
- Lifting and maneuvering heavy robotic assemblies; use of required PPE.
- Work around high-voltage electronics, powered actuators, and moving machinery.
Your day begins on the lab floor assembling…
(If this job is in fact in your jurisdiction, then you may be using a Proxy or VPN to access this site, and to progress further, you should change your connectivity to another mobile device or PC).
View / Apply for Jobs
Matching My Jurisdiction