Electrical Engineer

As our Staff Electrical Engineer, NPI, you'll carry the power electronics, distribution, and energy storage subsystems from concept through production release across every RELIC configuration, and produce the design packages, validation evidence, and engineering transfer each phase depends on. You'll work alongside our mechanical, manufacturing, and reliability engineers, and

set the electrical standard the product line is built to. Travel: up to 10%

• Drive the power electronics, distribution, and energy storage subsystems from concept through production release and field support on each product configuration
• Define subsystem engineering requirements from the product requirements document, assess technology availability, and complete the preliminary risk assessment at concept
• Drive DFM, DFA, serviceability, reliability and compliance efforts in close partnership with internal stakeholders and external manufacturing partners
• Govern electrical change management from change request and impact assessment through approval, drawing and bill of materials revision, and effectivity on the line
• Plan and complete engineering transfer to manufacturing and operations across drawings, specifications, process inputs, and open issue handover

• Lead the power electronics and distribution design from the DC tap at the host plant
• through conversion, harness and interconnect, and the compute load
• Specify protection coordination and device selection across the unit, including short circuit calculation, breaker and fuse sizing, and conductor and busbar ratings
• Lead the energy storage subsystem design across cell and pack specification, battery management, thermal runaway safety, and N-1 fault tolerance across parallel BESS units
• Integrate the inverter and power conversion equipment across configuration, parameter sets, grid and DC side interfaces, and vendor technical acceptance
• Design electrical safety into the product across isolation and disconnect architecture, stored energy hazards, touch safe barriers, labeling, and working clearances
• Publish and maintain the released electrical design package across schematics, single line diagrams, wiring and interconnect diagrams, panel layouts, cable schedules, and the calculations behind them

• Own the electrical design FMEA and hazard analysis from first draft through risk priority number reduction, mitigation closure, and sign off against the released design record
• Develop the electrical reliability and compliance test plans with quality and the reliability functions, covering accelerated life, environmental, and margin characterization testing
• Partner with the reliability function on test execution and failure analysis, supplying the hardware, test articles, and electrical interpretation each campaign needs
• Plan and execute electrical root cause investigations on production and field failures, from fault isolation and measurement through corrective action and design change

• Design, build, and commission the in line and end of line electrical test equipment, including fixtures, load banks, instrumentation, safety interlocks, and operator interfaces
• Support prototype and validation builds on the floor, resolve electrical build issues across termination access, routing, and build sequence, and feed findings back into drawings and work instructions
• Author the electrical work instructions, field termination procedures, and energizing checklists used by the assembly team and the field service group

• Bachelor's degree in Electrical Engineering (or equivalent industry experience)
• Experience:
  
  8+ years…