Skip to content
×

On-Site Chemical Process Engineer - Carbon Capture, Alkaline Electrolysis & Methanation Pilot at CCN

Job in Mundelein, Lake County, Illinois, 60060, USA
Listing for: Standard Carbon
Full Time position Listed on 2026-11-18
Job specializations:

Job Description & How to Apply Below

Job Description

Location: CCNY, Manhattan | Engagement: Contract-to-Hire | Company: Standard Carbon

Standard Carbon is seeking a hands-on Chemical Process Engineer / Commissioning Engineer to own our installed carbon capture, hydrogen production, and Sabatier methanation system at CCNY.

This is not a remote design role. We need an engineer who can operate real process equipment, troubleshoot pumps, heat exchangers and controls, review P&IDs, manage trades, coordinate PLC changes, and validate the plant against DWSIM and Aspen HYSYS.

Goal: convert the CCNY pilot into a reliable automated demonstration plant that an authorized user can start with essentially one command through the Unitronics HMI/web/mobile interface.

Process and Current Condition

The CCNY deployment demonstrates Standard Carbon's the Carbon Bridge process:

Combustion exhaust → MEA CO₂ capture → CO₂ conditioning → hydrogen production → Sabatier methanation → water removal → methane production/use

Approximate design basis: 3.9 kg/h CO₂ utilization, 0.7 kg/h H₂, 1.5 kg/h methane, ~35 kW electrolysis, 115°C

  • sufficient temperature through HX-102 / line 112 for CO₂ desorption
  • The desorber inventory appears large relative to the MEA flow receiving reactor heat. Measure actual flows, temperatures, inventory, exchanger performance and losses and close the real thermal balance.

    Initial Semi-Batch Strategy

    Before major expansion, establish and automate a semi-batch mode:

  • Load the MEA with CO₂.
  • Stop additional absorption/loading.
  • Reduce unnecessary cooling.
  • Bring methanation reactors to temperature.
  • Circulate MEA through reactor heat recovery and heat the desorber inventory.
  • Confirm actual CO₂ release.
  • Start hydrogen production/methanation and automatically maintain H₂:

    CO₂ ratio.
  • Continue until desorbed CO₂ declines, then return to the next capture cycle.
  • Permanent Thermal Solution

    Calculate MEA regeneration heat demand, reactor heat generation, exchanger effectiveness, circulation rates, desorber thermal inventory, heat losses, required H₂/methanation capacity, cooling requirements, and startup versus steady-state loads.

    Implement the appropriate combination of added hydrogen/methanation capacity, improved heat recovery, heat exchangers, active cooling, instrumentation, automated valves, and supplemental boiler/electric heat if required. Methanation heat should satisfy as much of the desorber load as practical.

    System 200 – Standard Carbon Alkaline Electrolyzer

    Replace the temporary PEM units with Standard Carbon's in-house alkaline electrolyzer and commission its balance of plant: ELE-201 stack, DC power supply, ~30% KOH electrolyte loop, C-201 O₂ separator, C-202 H₂ separator, P-201, HX-211, EH-201, instrumentation, automated XV valves, O₂ vent/H₂ routing, C-203/C-204 cooling/separation, P-202, HX-201, CH-201, condensate handling, H₂ drying, EH-202, PR-201, H₂ analysis and PLC I/O.

    Manage the mechanical, electrical, controls and commissioning transition from PEM to alkaline electrolysis.

    System 300 – Methanation

    System 300 includes REA-1/REA-2 parallel primary reactors, REA-3 polishing reactor, EH-301/EH-302/EH-303 heaters, temperature/pressure instrumentation, H₂/CO₂ feed, FIT-301/FCV-301 CO₂ control, ~3.9:1 H₂:

    CO₂ target, reactor-to-MEA heat recovery, condensate removal, gas drying, AIT-301 methane measurement, AIT-302 residual CO₂ measurement, and methane storage/vent/supply routing.

    Optimize conversion, cooling, condensate removal, flow distribution, heat recovery, gas composition, controls and reactor capacity.

    Controls and Automated Demonstration

    The final system must provide a single-command automated demonstration. An authorized user should press START DEMONSTRATION, after which the Unitronics PLC verifies permissives and automatically sequences…

    To View & Apply for jobs on this site that accept applications from your location or country, tap the button below to make a Search.
    (If this job is in fact in your jurisdiction, then you may be using a Proxy or VPN to access this site, and to progress further, you should change your connectivity to another mobile device or PC).
    View / Apply for Jobs
    Matching My Jurisdiction

    Search for further Jobs Here:

    SEARCH JOBS: 10+ Million Listings
    (Try combinations for better Results! Or enter less keywords for broader Results)
    Education Level
    Experience Level (years)
    Posted in last:
    Salary