Welder Fitter Fabricators - 2nd SHIFT

• Base Pay $20.00 - $33.00 / Hour
• Job Category Welding
• Industry Manufacturing
• Employee Type Full Time Non-Exempt

We are looking for flux-cored welders with experience in custom/structural steel fabrication, to perform the following duties:

• Setting up 600 amp wire feed welders
• Experience in the use 100 ton cranes
• Use of cutting and heating torches
• Grinding
• Drilling
• Taping
• Sawing
• Use of an iron worker
• Overhead crane use
• Ability to work from scaffolding

• Flux-cored welders with experience in custom/structural steel fabrication
• 2nd shift:
  Mon-Thurs, 2pm to 12:30am; extra $1.50/hour for 2nd shift.
• Candidates should have experience on weld fillets ranging from 1" to 2"; must be able to perform multi-pass welds, as well as gauging and grinding.
• We will accept entry-level welders for 2nd shift (pay range for entry level is $20-$25)
• Technical training and/or experience required
• Hourly wage is dependent on experience and capabilities; please include your wage expectations with your resume; extra $1.50/hour for 2nd shift
• There will be occasional overtime to the 40 hour work week

Linita Design & Manufacturing specializes in the manufacturing of Water Control Equipment such Intake Gates, Bulkhead Gates, Stoplogs, Trash racks. Cranes, Hoists, etc. We are also a heavy custom fabrication shop.

Competitive pay based on experience.

• Overtime opportunities
• 401(k) with employer matching
• Dental and Vision Insurance; 90% paid by employer
• Health insurance
• PTO
• 100% paid short and long-term disability insurance
• Life insurance policy of $50k

• 8-10 hour shift - 2nd shift;
  Mon-Thurs 2pm-12:30am

Salary is dependent on experience and capabilities; please include your salary expectations with your resume