3rd Shift Burnishing Operator

Description

Nemco Food Equipment is committed to the manufacturing and on-time delivery of these piece parts to the assembly operations with a very experienced staff of laborers who can operate a variety of work centers able to prepare and polish raw castings and components into quality parts. In this job, you will work in a production environment, continuously tending to machine. After an initial training period, productivity and quality requirements must be met.

Durations of set-ups and run times will vary. Tasks require a moderate degree of eye-hand coordination, manual dexterity, and the use of both hands and arms on a repetitive basis for a full range of motion. The responsibilities of this position include, but are not limited to, the following:
Polishing of parts using burnishing tanks and/or sandblaster.

Ability to keep an accurate count of inventory.

Responsible for time management.

If this job is as one of interest to you, at a minimum, you must have, or the initiative to learn the following:

• Ability to set up and operate metal finishing machinery.
• Ability to read blueprints and follow specific written instructions and procedures.
• Ability to keep the workspace clean and organized.

Experience as a machine operator in a production environment is preferred.

• This is a 3rd shift position. You will start on 1ast shift and after an initial training period, productivity and quality requirements must be met. Training is expected to last about 3 weeks, at which time you will move to 3rd shift.
• Sunday night - Friday morning (9:00pm - 5:00am; 8-hour shift 20 minute paid lunch)
  Subject to Change
• Occasional overtime is required

• Standing: Most tasks are performed in a standing position with intermittent walking.
• Lifting: Frequently lifting items weighing 5 lbs. to 10 lbs.; occasionally lifting items weighing up to 50 lbs.
• Walking: Frequent walking short distances (less than 1/8 mile).
• Carrying: Occasional carrying bulky items weighing up to 50 lbs. short distances.
• Pushing: Use of manual hand truck and carts to occasionally move skids or parts short distances.
• Pulling: Use of manual hand truck and carts to occasionally move skids or parts short distances.
• Bending: Frequent bending is required to perform a variety of tasks.
• Reaching: Frequent reaching to load and unload parts from fixtures in machine, tubs, carts, or pallets.
• Handling: Frequent handling of parts ranging in weight from 5 lbs. to 10 lbs.
• Gripping: Frequent gripping of parts while operating the burnisher.