2nd Shift Cross Functional Entry Level Operator

POSITION SUMMARY

Responsible for the operation of production equipment to produce quality product meeting Wayne Metals and customer specifications.

• Associate will be training in three key areas for entry level operator:
  ASSEMBLY
  , LASER DENESTING
  , and SPOT WELD
  • An Assembly operator will be able to perform the general assembly operations required for the jobs within the department. He consistently meets or exceeds production standards and/or expectations.
  • A Laser Denester will be able to perform operations of the laser denesting area, including overhead crane operation and certification.
  • Spot Welder will be trained to run all of the equipment and jobs within the department and can do all set-ups. He/she must consistently meet or exceed production standards and/or expectations.
• Under the direction of the area manager or instruction of a Team leader, Cross Functional Operator will be assigned to run production and / or setup equipment upon which he has been trained.
• The operator must have the ability to read, write and perform arithmetic. The operator is responsible for the production counts being reported accurately.
• The associate should have the ability to use hand tools related to the various machines, which he/she will be required to operate or assist in operating.
• Operator must maintain a safe, clean, orderly and hazard-free work area, always promote safety and have knowledge of all safety rules, seeing that all work is done in a safe manner. He/she will report any unsafe condition to his immediate supervisor.
• Operator must comply with all Wayne Metals, LLC quality system requirements, defect/error prevention, waste reduction, and WM standards. Will be trained and use SPC systems in place for production operations.
• Operator should understand production efficiency and ensure he/she is performing per the rates specified and understand that if the rate is too tight or too loose, he/she should advise the Team Lead and/or Area Manager.
• The operator shall be aware of the Manufacturing Goals for the Company.
• Operator will be responsible for labor reporting through the Visual Manufacturing System; it is critically important to our process, inventory control, cost accounting, capacity planning and staffing. The operator must follow the procedure for labor entry closely and advise his / her superior when there is a problem.

High school graduate or equivalent training or work experience.

• Knowledge of arithmetic
• Knowledge of blueprint reading
• Knowledge of defects

• Conform to all Wayne Metals, LLC environmental policies, programs and procedures.
• Conform to all State of Indiana laws and regulations.
• Report any environmental concerns to Supervisor, Environmental Management Representative, Operations Manager, or GM.