QA/QC Inspector
-
Quality Assurance - QA/QC
Job Description & How to Apply Below
The QA/QC Inspector I performs visual inspection and verification of material, equipment, piping systems, welding, and brazing installation work on assigned projects and in fabrication shops and records each result as objective evidence. The position works to project specifications, ASME piping codes, manufacturer requirements, and customer site requirements, under the direction of the assigned QA/QC Inspector III and within ACCO’s welding program requirements.
QA/QC Inspector I is the entry inspection level, below Inspector II and III. Assigned alone to a project or shop, this position performs the inspections in its scope and produces a complete, retrievable record of each one, working to an inspection plan set by the QA/QC Area Supervisor or the assigned Inspector III rather than writing that plan itself. Where an Inspector II or III is also assigned, daily technical direction comes from them;
where neither is, it comes from the next QA/QC manager in line.
QA/QC supports fabrication, installation and project management. Those groups are this position’s customers inside ACCO, and what they build is what reaches the contractual customer. The position works as part of the project team — available, responsive, and practical about how the work gets built — not as an outside check on it. Findings are raised to be resolved. Getting to the work early, before it is covered, is part of the job.
Field and shop personnel take day-to-day direction from local project leadership (Project Management, Foreperson, General Foreperson, or Superintendent) on a dotted-line basis: where to be, when, and how the day is coordinated, with site adherence to appropriate conduct and safety in mind. Inspection decisions, acceptance and rejection, and the quality record run through the QA/QC line to the assigned QA/QC Inspector III, then the QA/QC Area Supervisor and the QA/QC Regional Manager.
Where the two pull against each other the QA/QC line governs the quality decision, and the conflict is raised the same day rather than settled on site.
Inspection
Perform visual examination of welded, brazed, soldered, and mechanical joints, including grooved couplings, press fittings, flanges, and threaded connections.
Inspect pipe fit-up, alignment, joint preparation, cleanliness, support and hanger installation, and general workmanship.
Perform receiving inspection of material and equipment against the submittal, packing list, and required documentation.
Perform in-process and final visual inspection of high-purity process piping, clean utilities, chemical and gas systems, hydronic systems, and HVAC mechanical systems.
Attend hold and witness points as scheduled, and participate in pressure tests, system walkdowns, punch-list inspections, and pre-turnover verification.
Other duties as assigned by QA/QC leadership, in conjunction with the project team.
VerificationVerify compliance with project specifications, customer site requirements, ASME B31.1, B31.3, B31.5, and B31.9, AWS D1.1 and D1.3 where applicable, manufacturer requirements, and ACCO procedures.
Verify that the welding procedure specification in use is approved and applicable, and that welder qualification and continuity are current for the process in use.
Verify material traceability — heat numbers, material test reports, and lot identification — for the work inspected.
Verify that measuring and test equipment in use is within its calibration period.
DocumentationSubmit a daily inspection report with photographs on every project day worked, filed to the project QA/QC folder the same day.
Complete inspection records, weld maps, fit-up logs, brazing logs, torque logs, and visual inspection records legibly and contemporaneously with…
(If this job is in fact in your jurisdiction, then you may be using a Proxy or VPN to access this site, and to progress further, you should change your connectivity to another mobile device or PC).
View / Apply for Jobs
Matching My Jurisdiction