Manager - Testing & Commissioning - Wind Turbine Specialist
Listed on 2026-09-20
-
Energy/Power Generation
Electrical Engineering -
Engineering
Electrical Engineering, Test Engineer, Systems Engineer
Testing amp Commissioning Manager Wind Turbine Specialist
Position Overview This position is responsible for the planning execution coordination and technical assurance of commissioning activities for Wind Turbine Generators WTGs in utility-scale wind power projects The role ensures that mechanical electrical control protection and grid-interface systems of WTGs are commissioned safely operate reliably and fully comply with OEM requirements statutory regulations and grid codes prior to handover
Detailed Core ResponsibilitiesA Engineering amp Pre-Commissioning Planning- Review and provide inputs to engineering team to take care of engineering itself based on experience
- Grid compliance and WTG controller limits
- Machine specific challenges faced if any
- Participate in FAT review of WTG control and protection systems where applicable
- Develop WTG commissioning procedures method statements and risk assessments
- Coordinate commissioning sequence planning with EPC OEM and grid operator
- Supervise and verify correct completion of Mechanical erection torquing alignment and lubrication
- Electrical installation LV MV transformers grounding systems
- Ensure readiness of auxiliary systems Pitch and yaw drives
- Hydraulic and lubrication systems
- Emergency and service power supplies
- Lead pre-energization checks including Insulation resistance tests
- Grounding continuity
Sensitivity L amp T Construction Internal Use Phase sequence and voltage checks - Coordinate transformer energization and LV MV energization
- Execute first grid synchronization and progressive power ramp-up
- Ensure safety compliance during live tests and rotating machinery operation
- Validate WTG controller parameters as per grid code and PPC philosophy
- Coordinate LVRT HVRT frequency ride-through and reactive capability tests
- Verify pitch-based power regulation and ramp-rate control
- Confirm correct response to curtailment trip and fault conditions
- Support trial run availability tests and performance acceptance
- Review SCADA data alarms and event logs
- Close commissioning punch points and support COD documentation
- Conduct knowledge transfer and basic training for O amp M teams
Responsible for commissioning and grid-compliance testing of wind turbine generators as per IEC 61400-1 IEC 61400-21-1 IEC 61400-25 IEC 61400-27-1 IEC 60204-1 UL 6141 and any other relevant standards
Key Commissioning Tests Insulation amp dielectric testing of generators and transformers
Protection relay testing OV UV OF UF differential earth fault Functional testing of Pitch yaw mechanical brake
Emergency stops and fail-safe systems
Power curve and performance checks
Communication tests with plant SCADA and PPCKey Troubleshooting Scope Grid-related trips voltage frequency instability Pitch or yaw control faults
Excessive vibration or temperature alarms
Transformer or converter faults
Communication failures between WTG and PPCKey Competencies amp Skills Strong understanding of WTG electrical amp control systems Familiarity with IEC 61400 series and grid code requirements Ability to analyze turbine event logs and operational trends Experience coordinating multi-disciplinary OEM teams High safety awareness for rotating equipment and work at height
Minimum Qualifications Bachelor s Degree Electrical / Mechanical Engineering.
12 15 years of WTG commissioning experience.
OEM commissioning authorization strongly preferred.
Certified Engineer.
(If this job is in fact in your jurisdiction, then you may be using a Proxy or VPN to access this site, and to progress further, you should change your connectivity to another mobile device or PC).