Quality & Development Engineer

Duties and Responsibilities CAD Operator

• Development of the customers products on CAD.
• Liaise with Customers' engineers developing products from CAD through the prototype phases into production.
• Update the company's drawings.
• Design and draw the company's production tooling.
• Prototype manufacture through to serial production.
• Working with M.D., to manufacture prototype parts to meet the customer requirements.
• Document each phase with interim works instructions.
• Test completed parts to drawing requirements.
• Initiate the FMEA, control plan, flow chart documentation, progressing them through the build phases into the final PPAP pack.
• Carry out 'Run at Rate' studies where applicable.
• Prepare IMDS for all new products as applicable.
• Liaise with Customer Quality Department in the PPAP approval process.

• Inspection of incoming goods in support the administrator.
• Reject any batch and issue 8D report to supplier.
• Manage 8D Reporting system for supply base.
• Maintain Quality objectives. Introduction of new child parts.

• Inspect part to FPI or customer drawing.
• Complete supplier ISIR procedure.
• Raise audit record sheet. Calibration.
• Maintain in-house calibration system.

• Carry out internal audits as requested by the quality director.

• Carry out external audits.

• Carry MSA studies annually with Q.D.

• Customer Rejection procedure.
• Raise or complete 8D inspection report.
• Liaise with customer to either replace or rework parts.
• Investigate customer concern with works supervisor and establish root cause.
• Complete 8D report and return to customer.
• Update PPAP documentation if required.
• Update works instruction.
• Manage the company PPM quality objective.

• Lessons Learned Log
• Continuous Improvement and Preventive Action Logs
• Change Control system.
• Lessons Learned records.
• Cost of Quality records.

• Maintenance of the company's plant and equipment.
• Maintenance of critical spares.