QC Inspector

Join to apply for the QC Inspector role at Omega Electronics Manufacturing Services
.

This range is provided by Omega Electronics Manufacturing Services. Your actual pay will be based on your skills and experience — talk with your recruiter to learn more.

$24.00/hr - $27.00/hr

QC Inspector will perform inspection and determine compliance of partially or fully completed printed circuit assemblies to defined acceptability standards.

• Ability to complete PCB & PCBA level inspections competently.
• Scan boards inspected in the data collection system.
• Raise and review Technical Inquiries for any discrepancies as observed.
• At the end of the shift, make sure the working areas are clean.
• Escalate all issues to Supervisor / Engineer / Manager. If matters are unresolved, notify the Quality Manager immediately.
• Attend training as identified and implement all procedures pertaining to QMS.
• Be able to associate defects to workmanship standards specified by IPC (class 2 and
  3) as well as custom requirements.
• Recommend opportunities for improvement.
• Read and understands Omega Quality Management System (QMS).
• Read and understands Omega Quality Policy.
• Fill out any appropriate forms or records as required.
• Complete all other duties as assigned by management.

Other duties may be assigned.

• More than 5 years working in an electronics inspection environment within the CM or similar environment.
• Previous IPC-A-610 or J-STD-001 experience preferred.
• Must possess good working knowledge of CM technology (specifically circuit board assembly).
• Ability to read, write and communicate effectively in English to the degree necessary to perform the job.
• Knowledge of industry standard workmanship requirements (IPC-A-600 / IPC-A-610).
• Ability to visually verify fine detail work.
• Ability to understand and follow directions inspecting printed circuit assemblies (PCA’s).
• Proficient at reading and interpreting blueprints, drawings, bills of material, etc.
• Basic competence with MSWord, Excel and Outlook (or equivalent preferred).
• Ability to work under pressure and prioritize tasks.
• Must be able to sit for long periods of time conducting work while looking through a microscope or other magnification device.

• Possess and demonstrate good team relations skills.
• Demonstrated ability to follow instructions and achieve goals and tasks.

Mid-Senior level

Full-time

Quality Assurance

Non-profit Organizations, Hospitals and Health Care, and Medical Practices