CMM Engineer

About VAT Group

At VAT, we change the world with vacuum solutions. As the world’s leading supplier of high-performance vacuum valves, we have been driving innovation for more than 60 years. With over 3,200 employees worldwide, we operate from our headquarters in Haag, Switzerland, with manufacturing sites in Switzerland, Malaysia and Romania, as well as sales and service hubs around the world. We are guided by our passions: integrity, teamwork, customer centricity, and innovation – always working together as #oneVAT.

Location:

Haag, St. Gallen, CH

Employment Type:

Permanent

At VAT, we change the world with vacuum solutions. As the world’s leading supplier of high-performance vacuum valves, we have been driving innovation for more than 60 years. With over 3,200 employees worldwide, we operate from our headquarters in Haag, Switzerland, with manufacturing sites in Switzerland, Malaysia and Romania, as well as sales and service hubs around the world. We are guided by our passions: integrity, teamwork, customer centricity, and innovation – always working together as #oneVAT.

Joining us means becoming part of a passionate, international team where your voice is heard, your ideas matter, and your career growth is supported.

• Create and optimize offline measurement programs based on CAD models using Mitutoyo systems.
• Perform tactile and scanning 3D measurements and ensure that measurements are carried out correctly by CMM operators.
• Support and assist with deviation, corrective action, and improvement processes in production and with suppliers.
• Advise and support internal specialist departments on all measurement-related and process-related matters.
• Promote professional exchange, collaboration, and knowledge transfer within measurement and production engineering.
• Contribute to the introduction of new products, including the preparation of product‑specific production inspection plans.
• Perform initial measurements and validate measurement results as part of new product introductions.
• Apply statistical methods (SPC) to monitor, control, and continuously improve production processes.
• Use statistical and quality software, particularly Q‑DAS, to analyse and evaluate process data.
• Support and provide technical guidance to CMM operators in their daily work.

• Basic technical training, ideally with experience in machining technology.
• Very good German skills and preferably good English skills.
• Several years of professional experience in coordinate measuring technology, CMM programming, and the use of optical inspection systems, ideally Mitutoyo systems.
• Sound knowledge of reading and interpreting technical drawings, particularly regarding geometrical and positional tolerances.
• Good knowledge of materials, particularly aluminium and stainless steel.
• Strong knowledge of mathematics and descriptive geometry, as well as good spatial awareness.
• Good knowledge of relevant standards and quality requirements.
• A high degree of independence and the ability to provide technical support to CMM operators.
• Strong teamwork and collaboration skills when working with different specialist departments.
• Very good communication skills and a confident manner in a technical environment.
• Further training in ISO GPS is an advantage.
• Experience with Model-Based Definition (MBD) is an advantage.
• Willingness to work in a two‑shift system.

We believe in meaningful careers, continuous learning, and equal opportunities for everyone to drive our innovation and success. We welcome applicants from all backgrounds and are dedicated to fostering an inclusive and respectful workplace. If you have concerns, our compliance channel is available at our website. All reports are handled with strict confidentiality and in accordance with our Code of Conduct.