Instrumentation, Controls and Electrical; IC&E) Technician
-
Energy/Power Generation
Job Description & How to Apply Below
- Posted on November 3, 2026
Showing 1 location
Altavista
Altavista, VA 24517, USA
- On-site
- Pay or shift range: $40 USD to $46 USD The estimated range is the budgeted amount for this position. Final offers are based on various factors, including skill set, experience, location, qualifications and other job-related reasons.
- Full-Time
- Requisition #: SENIO
008162
Altavista Power Station is a 51-MW biomass-fired renewable energy facility located in the Lynchburg, Virginia metropolitan area near the Blue Ridge Mountains. The station generates electricity from sustainably sourced biomass using two B&W boilers, a Mitsubishi steam turbine, and an Alstom generator. NAES maintains a long-standing operating partnership with the facility's utility owner, and the station remains an important part of its long‑term generation portfolio.
OpportunitySummary
The Instrumentation, Controls, and Electrical (IC&E) Technician at Altavista Power Station supports the safe and reliable operation of the facility's instrumentation, control, and electrical systems. This position performs calibration, testing, troubleshooting, maintenance, and repair of equipment associated with biomass fuel handling, boilers, steam turbines, and emissions controls. Working closely with plant personnel, the IC&E Technician supports equipment reliability, operational efficiency, and compliance with safety and environmental standards.
Yourscope of responsibility as IC&E Technician includes the following primary functions:
- Perform installation, calibration, testing, troubleshooting, repair, and maintenance of instrumentation and control systems, including PLCs, DCS, control valves, dampers, transmitters, analyzers, and biomass fuel handling controls.
- Develop, modify, and optimize PLC and DCS control logic, including ladder logic and control sequences, in coordination with engineering and plant personnel to improve system reliability and performance.
- Execute preventive, predictive, corrective, and emergency maintenance on electrical equipment, including switch gear, motor control centers, transformers, motors, batteries, inverters, chargers, and generator excitation systems.
- Calibrate pressure, temperature, flow, and level instrumentation, as well as continuous emissions monitoring systems (CEMS), using appropriate diagnostic and calibration equipment.
- Troubleshoot control and monitoring systems associated with biomass‑fired boilers, combustion controls, fuel conveyors, feed systems, steam turbines, and auxiliary equipment.
- Conduct turbine control system inspections, calibration, and functional testing to support reliable start‑up, shutdown, and continuous operation.
- Optimize boiler combustion controls, burner management systems, and emissions control equipment, including selective non‑catalytic reduction (SNCR), lime injection systems, spray dryers, and particulate collection systems.
- Coordinate contractors, vendors, and OEM representatives during maintenance projects, equipment repairs, and planned outages to ensure safe, timely, and effective execution.
- Maintain accurate maintenance records, calibration data, equipment modifications, technical drawings, and work orders using the computerized maintenance management system (CMMS).
- Promote safe work practices through hazard identification, lockout/tagout (LOTO), electrical safety procedures, and compliance with applicable environmental and regulatory requirements.
- Support equipment reliability and continuous improvement through root cause analysis, troubleshooting, procedure updates, and implementation of corrective actions.
- Assist with additional maintenance and operational activities as needed to support safe and reliable plant…
(If this job is in fact in your jurisdiction, then you may be using a Proxy or VPN to access this site, and to progress further, you should change your connectivity to another mobile device or PC).
View / Apply for Jobs
Matching My Jurisdiction