Tooling - 2nd Shift

• All die coordinators must be qualified to inspect and recognize tooling that needs to be repaired, replaced or revised.
• Machine scheduled walk through –verify all items that are planned are at the machines. All other tooling should be pulled, inspected and returned to proper locations.
• Pull a printing plate backlog once a shift. All items must be inspected and staged if they meet requirements.
• Pre/post inspection of cutting dies – pre-inspect and tag cutting dies once a shift. All shifts are required to pull and put away cutting dies as it is returned from the machines. If dies are too large or too heavy to handle alone, get someone to assist.
• Let Tooling Coordinator know of dies or plates to be modified, repaired or replaced. Then notify Superintendent and Supervisors of the status of the tooling ‘In-House Repair’ or ‘Outside Repair.’ Responsible for all tooling PO's. Monthly tooling spread sheets. Check in all incoming print plates. Assign print plate & cutting die #'s from the Print or Cutting Die Log Book. Keep up die spread sheets.
  
  Assign location to all print plates and enter it into HRMS. All supporting documentation will be attached and delivered to die room. Responsible for all out going tooling. Order tooling and supplies when needed. Help scan print cards and cads in system, if applicable. Get quotes for tooling when needed. Responsible for all tooling bill of ladings that are sent out.

• All die coordinators must be qualified to inspect and recognize tooling that needs to be repaired, replaced or revised.
• Machine scheduled walk through –verify all items that are planned are at the machines. All other tooling should be pulled, inspected and returned to proper locations.
• Pull a printing plate backlog once a shift. All items must be inspected and staged if they meet requirements.
• Pre/post inspection of cutting dies – pre-inspect and tag cutting dies once a shift. All shifts are required to pull and put away cutting dies as it is returned from the machines. If dies are too large or too heavy to handle alone, get someone to assist.
• Let Tooling Coordinator know of dies or plates to be modified, repaired or replaced. Then notify Superintendent and Supervisors of the status of the tooling ‘In-House Repair’ or ‘Outside Repair.’ Responsible for all tooling PO's. Monthly tooling spread sheets. Check in all incoming print plates. Assign print plate & cutting die #'s from the Print or Cutting Die Log Book. Keep up die spread sheets.
  
  Assign location to all print plates and enter it into HRMS. All supporting documentation will be attached and delivered to die room. Responsible for all out going tooling. Order tooling and supplies when needed. Help scan print cards and cads in system, if applicable. Get quotes for tooling when needed. Responsible for all tooling bill of ladings that are sent out.

Will fill in on all vacations on machine centers or as needed.

starts $18.98 plus shift differential. You are eligible for a pay rate increase at 90 days and 6 months (based on attendance and performance) that will quickly increase pay to over $20. This is just the beginning of earning potential tt promotes from within! This is not a job but a CAREER!

High school diploma or GED.

• Prior work experience in the corrugated industry.
• 6 months experience in the Press or Finishing Department.

Able to read and follow instructions on factory masters.

Able to read a tape measure with speed and accuracy. Able to calculate figures and amounts such as percentages, measurement, volume and rate. Able to apply concepts of high school math.

Ability to apply common sense understanding to carry out…