Mandrel Process Operator - Off Shift

SUMMARY OF POSITION

Responsible for operating mandrel inspection and mold machines, set laser O.D. and mandrel lube operation.

Responsible for operating mandrel inspection and mold machines, set laser O.D. and mandrel lube operation.

• Must be capable of following and meeting standard work requirements including but not limited to:
• Selecting proper mandrel and set-up inspection and mold and/or weld machine, prepare tank with correct lube and set proper traverse setting
• Operating mold machine, paying particular attention to any defects like cracks, excess rubber, alignment of mold and smoothness of outer surface
• Measuring the O.D. of mandrel with O.D. and/or Pi tape or sliding calipers to determine if the mandrel is within the specification limits of diameter and ovality.
• Preparing the lube tank, agitate the lubricant properly, and apply a consistent application of lubricant to the mandrel.
• Operator will ensure quality by identifying and eliminating known defects by cutting out any known defects and splicing ends together.
• Assure all necessary documents required are properly prepared and completed.

• Work safely in accordance with regulations, standards, and procedures in a manner that eliminates risk to health and the environment. Notify leadership of unsafe conditions or practices unlawful activities and activities which present unreasonable health and/or environmental risk. Report all safety and/or environmental incidents to leadership immediately.
• Prevent excess waste of product and/or components by operating the equipment in an efficient manner.
• Maintain production schedules.
• Participate in peer-based teams (i.e., Natural High Performance Teams), and work with groups to initiate and implement programs such as Lean Manufacturing and 5-S.
• Other duties may be assigned later.

Education required:

High School diploma or GED

Production work preferred but not required

• Good verbal and interpersonal communication skills
• Basic knowledge and use of hand tools
• Sound decision making skills
• Good math, reading, writing skills
• Demonstrated mechanical aptitude
• Mental and visual acuity for production of quality product
• Strong trouble shooting skills

• Basic computer skills – Microsoft Office package
• Ability to lift up to 50 pounds

Ability to work well in a team environment

Employee must pass Pre-employment screening

• Report directly to Value Stream Team Leader
• Work closely with Maintenance to resolve issues with the equipment

Work Requirements
None at all
Occasional
Frequent
Continuous
% of Workday (8 hr)
0%
1-33%
34-66%
67-100%
Repetitions per hour
4-6
6-12
>12
Lift / Carry
Up to 10 lbs.
11-30 lbs.
Bending
Twist / turn
Reach below knee
Push / pull
Squat / kneel
Stand / walk
Sit
No lifting above shoulders

• Required PPE:
  • Safety glasses
  • Kevlar gloves
  • ANSI Z41 Safety Shoes
• Standing is required for extended periods of time. Walking, bending, reaching, pushing, pulling and grasping are done on a frequent basis. Climbing, carrying, stooping, lifting and lifting overhead are performed on an occasional basis.
• Requires high degree of manual dexterity, which could be performed under restrictive conditions.
• Requires flexible hours and short notice for overtime.

The employee may be required to follow other job-related instructions and to perform other job-related duties as requested, subject to all applicable state and federal laws.

The above statements are intended to describe the general nature and level of work being performed by employees assigned to this classification. They are not intended to be construed as an exhaustive list of all responsibilities, duties and skills required of employees assigned to this position.

Parker Hannifin is a Fortune 250 global leader in motion and control technologies. For more than a century, we've enabled engineering breakthroughs that make energy cleaner, transportation safer, medical treatments more effective, and manufacturing more efficient.

With…