FDM Design Release Engineer

23 hours ago Be among the first 25 applicants

Get AI-powered advice on this job and more exclusive features.

Direct message the job poster from DBSI SERVICES. INC

The Design Release Engineer will be responsible for the design, development, advance product & quality planning (APQP), and production release of a system/component within Fuels Systems:
Fuel/Urea tanks and fuel/urea delivery modules.

Other responsibilities will include but not limited to:
Quality improvements, value optimization, weight reduction, and other efficiency improvement initiatives including communicating technical product status to management.

The Design Release Engineer will interact with suppliers and will work closely with internal and external groups such as vehicle program team, testing & prototype labs, CAE engineers, supplier operations and manufacturing plants.

Requirements:

• Bachelor of Science degree in Mechanical Engineering, Mechatronics or Electrical Engineering is required.
• Proficiency in English (write, listen, and speak) is a requirement.
• BSME degree from ABET accredited university/or equivalent is preferred.
• 2
  -4 years of design/development automotive engineering experience in Fuel Systems and/or UREA.
• Will consider an internship with Fuel Systems (UREA also considered) as part of that experience.
• Self-starter with strong leadership, communication & organizational skills and demonstrated problem solving ability.
• Will be required to travel domestically and internationally up to 20%.
• Will be required to drive a company car. A valid driver’s license is required as well as a clean driving record.

Products: Fuel tanks, Urea (SCR) Tanks, Fuel delivery modules, Urea Delivery Modules, Gas and Diesel Filters.

Preferred Requirements:

• Injection molded/Blow molded Fuel/Urea tank design.
• Knowledge of fuel tank virtual simulations is highly recommended.
• PHEV experience is recommended
• Fuel Delivery Module design is recommended.
• Experience with Design Failure Mode & Effects Analysis (DFMEA).
• Experience with Design Verification Plan & Report (DVP&R).
• Design for Six Sigma (DFSS) preferred Belt certification.
• General understanding of fasteners/torque.
• General understanding of GD&T.
• General understanding of NX, Teamcenter, PLM.

Additional Must Haves:

• 1-2 years of design/development experience in Fuel Tanks, Fuel Delivery Modules, and/or Urea Tanks/Pumps
• Experience with Design Verification Plan & Report (DVP&R)
• Experience using 2D and 3D modeling CAD tools, e.g., NX, Teamcenter, and/or PLM.
• General understanding of Injection molded/Blow molded Fuel/Urea tank design.
• Onsite - 100% (CTC)

• Seniority level
  
  Mid-Senior level

• Employment type
  
  Full-time

• Industries Staffing and Recruiting and Motor Vehicle Manufacturing

Referrals increase your chances of interviewing at DBSI SERVICES. INC by 2x

Medical insurance

Vision insurance

401(k)

Paid maternity leave

Apply BELOW