Coating Wrapper

The purpose of the Coating Wrapper is to be responsible for wrapping finished rolls with plastic and inspecting for backing defects.

• Apply the roll ticket to the side edge of the wrapped roll.
• Ensure the correct roll ticket is on the wrapped roll – follow the roll sequence.
• Ensure the plastic is the correct width for roll size.
• Use core inserts to secure the plastic in place.
• Ensure every roll is quality wrapped (plastic is tight, no tears or holes, and the ticket is legible and not wrinkled).
• Communicate to the supervisor/lead any issues at the wrap station (poor seal, defective plastic, etc.).
• If there are any issues with the roll ticket sequence, communicate to the supervisor/lead ASAP.
• Communicate with the roll‑up operator on held and off‑quality rolls.
• Monitor backing for defects – communicate to the inspector any observed.
• Communication is crucial.
• Keep the area clean at all times.

• Able to sit, walk or stand throughout the shift.
• Able to lift and carry objects up to 80 lbs.
• Must be able to work in a repetitive motion and fast‑paced environment.

• High school diploma or equivalent preferred.
• Read and write effectively.
• Basic math skills.

• Overtime is required on occasion.
• All accidents/incidents must be reported immediately.
• Perform any other duties as required by management.
• Safety equipment must be worn when required, and safety requirements must be followed in all areas.
• Report any safety, quality, or production issues to management while performing the job.
• Responsible for safety, quality, and productivity of output.