CDL Driver​/Bronto Skylift Operator

job category: inspection and ndt services

requisition number: cdldr
006153

posted: february 18, 2026

employment type: full-time

• des moines, ia, usa
• houston, tx, usa
• odessa, tx 79763, usa

the cdl driver / bronto skylift operator (“operator”) transports and operates a bronto truck mounted aerial platform to support at-height inspection, maintenance, and construction projects. The role ensures full dot and fmcsa compliance while driving and champions safe work‑at‑height practices during lift operation. This is a part‑time, hourly position with frequent regional and occasional nationwide travel.

• safely drive bronto truck (up to 80 ft overall length) to and from project sites, complying with all federal, state, and local dot regulations, hours‑of‑service limits, and company routing instructions.
• perform and document pre‑trip, enroute, and post‑trip vehicle inspections, report defects promptly for corrective action.
• maintain accurate driver logs, fuel receipts, and mileage reports in accordance with fmcsa requirements.
• execute bronto skylift operations, such as: set up, level, and stabilize the bronto unit—including outriggers and safety systems—per manufacturer guidelines; operate aerial‑platform controls to position technicians and equipment at heights up to 290 ft for blade inspection, repair, or other services; monitor wind speed, load limits, and outreach sensors; cease operations when conditions exceed safe parameters; conduct routine maintenance, minor troubleshooting, and daily function checks on boom, hydraulic, and safety systems.
• promote a zero‑incident culture by enforcing mistras safety policies, osha fall‑protection standards, and bronto operator best practices.
• participate in random drug/alcohol testing, medical‑certification renewals, and required operator refresher courses.
• serve as on‑site subject‑matter expert for emergency‑descent procedures and aerial‑rescue planning.
• secure tools, rigging, and consumables in truck storage to prevent in‑transit damage or load shift.
• coordinate scheduled preventative maintenance with fleet and maintain service records for vehicle and lift.
• interface professionally with site supervisors and land/facility owners; communicate equipment capabilities, limitations, and job‑site needs.
• assist technicians with staging materials, ground support of work scope, coordinating lift sequences, and adhering to project timelines.

• complete all corporate and bronto‑specific operator training within 90 days of hire (or present proof of prior completion).
• wear required ppe and work in adverse weather conditions at heights exceeding 300 ft.
• valid cdl class b with air‑brake endorsement; clean motor vehicle record.
• current dot medical examiner’s certificate and ability to pass pre‑employment & random drug/alcohol screens.
• minimum 2 years commercial driving plus 1 year operating large aerial platforms or crane‑type equipment.
• acceptable aerial‑lift credential — any one of the following: ipaf mewp operator pal card; osha‑compliant aerial‑lift certification meeting 29 cfr ; ansi a92.24 mobile elevating work platforms operator training; bronto skylift factory operator course (accepted in lieu of above when completed within last 5 years).
• working knowledge of fmcsa hours‑of‑service, load‑securement, and vehicle‑inspection regulations.
• ability to read lift charts and site plans; strong radio/phone communication skills.

frequently climb ladders, ascend/descend boom, and lift or carry up to 50 lbs. Sit for extended periods while driving; stand on platform for prolonged tasks; work at height in harness.

mistras group, inc. Is committed to equal employment opportunity. Employment decisions—including initial hiring and all matters involving the terms and conditions of employment—will be made without regard to any protected class under applicable law. If hired, the employment relationship is “at‑will,” which means that employment can be terminated at any time, and for any reason, at the option of either the company or the employee.

Please direct questions about these policies to a…