Class A Fitter

Job Summary

Difficult fabrication of steel parts by reading blue prints and building to specifications using hand held power tools and track type oxy-fuel cutting apparatus with minimum supervision.

• Lay out rises, slopes and bevels using framing squares.
• Lay out and build fixtures.
• Pass tack weld test in 3F and 4F positions with F4 electrode group.
• Interpret structural steel blue prints (shop drawings).
• Be able to camber.
• Operate 90 angle grinder.
• Heat straighten using torch.
• Operate cutting torch.
• Utilize impact wrench to tighten bolts.
• Operate overhead pendent controlled bridge crane safely and efficiently.
• Fabricate truss and rolled beam.
• Operate radiograph/ track torch.
• Be qualified welder (class
  
  C).

Perform other duties as required by management.

• High school education or equivalent. Basic knowledge of ASIC code of standard practices and AWS D1.1 Chapter 3 (workmanship). Ability to read tape measure to 1/16 increments and add / subtract dimensions. Ability to read weld symbols and basic knowledge of structural steel fasteners. Must be able to lift/move a minimum of 50 lbs. Should be knowledgeable in procedures 401, 402, 403, 404, 405.

• Two or more years experience in manufacturing in the steel fabrication industry.
• Proficiency and use of Software, equipment, machines, tools, electronic device necessary for job.
• Squares (combination, bevel, frame), 90 angle grinder, crane, torch, impact wrench, radiograph/track torch, reamers, and magnetic drills.