Equipment Operator 2nd Shift (Certified Housing Cell Utility

Equipment Operator 2nd Shift (Certified Housing Cell Utility)

Eaton's AER FMC Fuel Motion Control Systems division is currently seeking an Equipment Operator 2nd Shift (Certified Housing Cell Utility) at our Euclid, Ohio plant facility! Core 2nd shift hours for this role are 3:30pm - 12am Monday - Friday. The hourly rate for this position is $28.98 plus $1/hr shift differential per hour. Please note the salary information shown above is a general guideline only.

Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations.

• Set-up, adjust and operate various milling and drilling equipment, hand and/or power equipment to burr, polish, finish, blend surfaces on machined parts and generate rough and finish dimensions on a variety of production parts.
• Perform visual and dimensional inspections and maintain accurate documentation on a variety of parts in accordance with ANSI Y14-5 and the certified operator program. Assistance may be given other operators on proper operational procedures.

• Set up, maintain and operate one or more milling machines, drilling machines, broaches, and/or shapers to generate rough and finish cuts on a variety of aircraft engine parts.
• Mount, change and align various jigs, fixtures. Equipment consists of power driven abrasive coated belts, strips, bobs, burrs, various hand tools, and disks together with the necessary holding fixtures and adaptors for the various size parts.
• Perform polishing; burring, and surface blending operations where finish dimensional, maintenance of contour, and other details are important and care and good judgement must be exercised to avoid damage to adjacent finished surfaces.
• Use templates, micrometers, comparators and other appropriate measuring devices to check dimensions and contour.
• Visually inspect for defects, check with micrometers, templates, profile gauges, and other precision type devices.
• Touch-up and/or replace tooling, adjust stops, select speeds and feeds, and gauge completed work with various precision checking equipment.
• Maintain accurate lot control (QCP 6.0) traceability, record keeping, log book entries, NCR's (QCP 11.0) and associated documentation.
• Generate close tolerance edge breaks using various hand tools.
• Maintain clean equipment and work area.
• Perform minor machine maintenance as needed.
• Chart and plot data per SPC requirement.
• Move material within the cell.

Required Qualifications:
• High School Diploma or GED from an accredited institution.
• Must reside within a 50-mile radius of Euclid, Ohio; no relocation benefit is provided.
• This position requires access to export-controlled information. To conform to U.S. Government export regulations applicable to that information, applicant must be a U.S. person, defined as a (i) U.S. citizen or national, (ii) U.S. lawful, permanent resident (green card holder), (iii) refugee under 8 U.S.C. 1157, or (iv) asylee under 8 U.S.C. 1158.
• Minimum one (1) year of machining or burr experience OR 2 Years work in an industrial manufacturing environment.
• Minimum 2-year GD&T Experience (successful completion of Eaton Level 1 Advanced Training will be considered in lieu of this requirement)

Position Criteria:
• Pass an Eaton vision test.
• Become a Certified Operator.
• Perform 5S and other duties as assigned.
• Complete Basics of Measurement courses
• Blueprint Reading 131
• Math Fundamentals 101
• Math:
Fractions and Decimals 111
• Units of Measurement 112