Manufacturing Technician - MCC Final - Weekend Shift-Fayetteville, NC

ATTENTION MILITARY AFFILIATED JOB SEEKERS - Our organization works with partner companies to source qualified talent for their open roles. The following position is available to Veterans, Transitioning Military, National Guard and Reserve Members, Military Spouses, Wounded Warriors, and their Caregivers. If you have the required skill set, education requirements, and experience, please click the submit button and follow the next steps.

Unless specifically stated otherwise, this role is "On-Site" at the location detailed in the job post.

Eaton’s ES AMER ARS PDCAD division is currently seeking a Manufacturing Technician I- MCC Final - Weekend Shift to join our team.

Shift

Hours:

Friday
- Sunday (6:00 AM- 6:00 PM). Overtime may exceed these hours, and can be mandatory at times.

The hourly rate for this position is $16 per hour.

Please note the salary information shown above is a general guideline only. Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations.

The Manufacturing Technician will assemble, fit and mount sub-assemblies, components, and standard and near standard fixed assemblies in Motor Control Centers, Enclosed Control and related assemblies and sub-assemblies. Perform assembly required for test preparation and final inspection. Assemble and wire units, relay panels, panel boards, space heaters, and control panels. Bend and install power cable and leads, fabricate pre-cable unit, panel and MTB harnesses, and power leads.

Use established power checking procedures and equipment to verify electrical/mechanical integrity of units assembled. Stage parts for customer orders.

• Work from oral or written instructions from supervision and/or prints, inspection reports, manufacturing information sheets, and standard or near standard wiring diagrams.
• Utilize manufacturing information sheets, determine necessary parts, write requisitions, and obtain materials from stock areas.
• Read shop orders and drawings to determine assembly procedures such as component types and configuration, mounting locations and clearances required.
• Assemble and fit parts and components to form sub-assemblies, or completed assemblies.
• Assemble and wire control devices, cutting wires to length.
• Make adjustments to insure correct alignment and clearances.
• Install units, pan assemblies and cover up steel, meters, kirk keys, pull boxes, reactors, relays, fuses, MTB assemblies, panel boards, space heaters, transformers, etc. by mounting/bolting into place. Assemble and install bus work such as lug adapters, cross over bus, splices, etc.
• Make pre-bent cable unit, MTB and control panel harnesses using pre-cable boards, control panels and hand crimp lugs if necessary. Cut, install and connect wire and/or cable in units where circuitry requires additional relays, timers, fuses, etc. Cut, form and connect control wire, power wire and cable, point to point on units, relay panels, control panels, and space heaters.

Auto req : 465437

Minimum Education Required
:
High School/GED

Job Category
:
Technician

• High school diploma or GED from an accredited institution
• Eaton will not consider applicants for employment immigration sponsorship or support for this position. This means that Eaton will not support any CPT, OPT, or STEM OPT plans, F-1 to H-1B, H-1B cap registration, O-1, E-3, TN status, I-485 job portability, etc.
• No relocation benefit is offered for this position. Candidates must reside within a 50-mile radius of Fayetteville, NC will be considered. Active-Duty Military Service member candidates are exempt from the geographical area limitation.

• Manufacturing or production experience preferred

• A basic understanding of electrical/electronic concepts and ability to read and understand standard electrical control circuits.

City
:
Fayetteville

State
:
North Carolina

Job Code
:
Manufacturing Manufacturing

Affiliate Sponsor
:
Eaton