Puller​/Sander​/Painter

Position Summary:

The Puller/Sander/Painter is responsible for separating parts from molds safety and securely as to not cause any damage as well as sanding and painting the part for a clean finish. The Puller/Sander/Painter will be required to use power tools (DA, Sander Tool) and must be experienced in reading a tape measure.

Responsibilities/Duties:

• Pull and separate molds from the part safely and securely.
• Sand parts down to a smooth finish for painting.
• Mix gelcoat and MEKP to hand paint small parts.
• Separate part from the mold once paint cures using a mallet and shims.
• Organize molds when not in use.
• Sort parts by the schedule and make sure they are located in the designated area for the cut booth.
• Ability to perform job functions safely and effectively in a fast-paced environment while wearing all required PPE and following safety policy.
• Must practice good housekeeping by keeping work areas clean at all times.
• Other duties as assigned.

Qualifications: To perform this job successfully, an individual must be able to perform each essential duty satisfactorily. The requirements listed below are representative of the knowledge, skill, and/or ability required. Reasonable accommodation may be made to enable individuals with disabilities to perform the essential functions.

Education and/or

Experience:

High School diploma or general education degree (GED); or one to three months related experience and/or training; or equivalent combination of education and experience.

Language

Skills:

Ability to read and comprehend simple instructions.

Mathematical

Skills:

General math skills required.

Reasoning Ability: Ability to apply common sense understanding to carry out detailed but uninvolved written or oral instructions. Ability to deal with problems involving a few concrete variables in standardized situations.

Physical Demands The physical demands described here are representative of those that must be met by an employee to successfully perform the essential functions of this job. Reasonable accommodation may be made to enable individuals with disabilities to perform the essential functions.

Continuous/C = 67-100%, Frequent/F = 33-66%, Occasional/O = 33%, None/N

Sits 0 hours

Stands 9 hours

Walks 1 hours

Drives 0 hours

Employee Lifts and/or Carries:

Maximum: 50 (lbs.) Frequently: 30 (lbs.) Occasionally: 10 (lbs.)

Employee uses Hands for repetitive activities:

Simple Grasping:
Right, Constant Left, Constant

Pushing/Pulling:
Right, Frequent Left, Frequent

Fine Manipulation:
Right, Frequent Left, Frequent

Employee uses Feet for repetitive activities:

Right:
None Left:
None

Employee is required to perform these activities:

Bending at Waist:
Occasional

Squatting:
Occasional

Climbing Ladders, Stairs:
Occasional

Kneeling on Ground:
Occasional

Reaching Above Shoulder:
Frequent

Work Environment The work environment characteristics described here are representative of those an employee encounters while performing the essential functions of this job (i.e., heat/cold, dust/dampness, height; chemical; noise; resin). PPE requirements are included. Reasonable accommodation may be made to enable individuals with disabilities to perform the essential functions.

PPE:
Safety glasses, N95 dust mask, hearing protection, cut resistant gloves, lightweight coveralls.

Competencies

To perform the job successfully, an individual should demonstrate the following competencies:

Teamwork: Balances team and individual responsibilities;
Exhibits objectivity and openness to others' views;
Gives and welcomes feedback;
Contributes to building a positive team spirit;
Puts success of team above own interests;
Supports everyone's efforts to succeed.

Motivation: Measures self against standard of excellence.

Quality: Demonstrates accuracy and thoroughness;
Applies feedback to improve performance;
Monitors own work to ensure quality.

Attendance/Punctuality: Is consistently at work and on time.

Dependability: Takes responsibility for own actions.

#Maverick Boat Group