Welder III 2nd Shift

Thompson Pipe Group is a privately held family business of engineers, contractors, and manufacturers based in Rialto, California. From the humble beginnings, we built a family of products to meet the needs of all kinds of infrastructure. Each generation of products is better than the previous .

Thompson Pipe Group is now the largest and most diverse drainage, sanitary, pressure and trench-less pipe provider, with manufacturing locations across the country and serving not just the US but all of North America. Please visit our website at

Thompson Pipe Group is currently looking for a Welder III 2nd Shift Star time at 5pm

This person willbe responsible forthe interior and exterior of every spirally welded cylinder that enters their designated station for welding defects, base metal defects, and dimensional tolerances and repairs those cylinders to meet specification requirements.

• Follow all safety rules, policies, and procedures.
• Inspections the entire interior and an exterior surface of spirally welded cylinders and perform repairs in compliance with AWWA C200 and additional job specifications as required.
• Reports repairs and dimensional measurements accurately of cylinders to the nearest 32nd of an inch.
• Utilize oxyacetylene cutting torch to square cylinder ends and perform repairs as needed.
• Performs minor maintenance and repairs to welding equipment and tools.
• Must properly use tools and care for e quipment provided by the company to complete job tasks.
• Maintain workstation by keeping it clean, organized, free from clutter and trip hazards.
• Work under general supervision; will report to a crew leader and/or supervisor.

• FCAW welder qualified to weld on Fittings and pipe and make repairs according to qualifications
  • Follow all safety rules, policies, and procedures.
  • Inspections the entire interior and an exterior surface of spirally welded cylinders and perform repairs in compliance with AWWA/ASME standards.
• Reports repairs and dimensional measurements accurately of cylinders to the nearest 32nd of an inch.
• Utilize oxyacetylene cutting torch to square cylinder ends and perform repairs as needed.
• Performs minor maintenance and repairs to welding equipment and tools.
• Must properly use tools and care for equipment provided by the company to complete job tasks.
• Maintain workstation by keeping it clean, organized, free from clutter and trip hazards.
• Work under general supervision; will report to a crew leader and/or supervisor.
• Problem Solving and Innovation:
  Works well alone and in groups to identify and resolve problems in a timely manner;
  Meets challenges with resourcefulness and generates suggestions for improving work;
  Exhibits sound and accurate judgment.
• Organizational Support:
  Follows all policies and procedures;
  Supports organization's goals and values
• Communication:
  Listens and gets clarification;
  Response well to questions; participates in meetings and demonstrates group discussion skills;
  Writes clearly and informatively;
  Reads and interprets written information effectively;
  Presents numerical data effectively.
• Self-Management
• The employee is occasionally exposed to fumes or airborne particles and risk of electrical shock
• There is machinery, moving equipment (cranes, bulldozers, and other moving equipment) and electrical hand tools at the job site
• Outdoors exposed to changing weather conditions (for instance, rain, sun, snow, wind, etc.)
• An improperly illuminated or awkward and confining workspace
• Working above ground level where the possibility of falling exists (i.e.on ladders, rooftops, bucket trucks, scaffolding)
• Loud (examples: metal can manufacture department, large earth-moving equipment)

Reasonable accommodations may be made to enable…