Electrical Final

Electrical Final

Reports To:

Department Lead

This position interconnects wired electrical panels to the environmental test chamber through following electrical schematics/blueprints/mechanical engineering drawings. The position also wires the components to the power panel.

• Cuts different gauge wires in pre-determined lengths
• Cuts interconnect in pre-determined lengths
• Checks in parts received from stockroom against pick list to verify part numbers and quantities
• Drills out J-Boxes

• Level I functions
• Reads and understands blue prints/specs/electrical schematics
• Reads and understands parts list
• Reads and understands cut list
• Wires switches
• Lays out J-Boxes and wire panels

• Level I and II functions
• Lays out location of J-Boxes
• Lays out and wires a job per engineering drawings

• Level I, II, and III functions
• Performs 110V job continuity test
• Performs point to point verification
• Quality checks a job

• Coordinates level I, II, III, and IV employees

• Possession of High School Diploma or GED required
• Preferred: industrial/commercial electrical experience
• Comprehension of blueprints, specs, and electrical schematics
• Experience with junction boxes, electrical conduit, and wiring
• Good math skills
• Accurately read a tape measure and wire gauge
• Experience using power tools including drill, grinder, cutoff wheel
• Ability to obtain the necessary tools for this position: tape measure, screwdriver, channel locks, wire strippers, hammer, nut drivers, crimpers