CNC Operator

Summary

Position will start in Oxnard, CA then must be willing to relocate to Henderson, NV January 1, 2027***

Operator 2 Salary Range: $20.00 - $28.00/ Hr.

Operator 2 operates CNC or manual machines.

• Follow safety requirements within the department.
• Access and understand daily and weekly schedules.
• Find, read & follow work instructions displayed electronically (iPad).
• Read and understand blueprints relative to the parts being produced.
• Correctly use all precision measuring instruments to verify part integrity.
• Correctly load and unload parts.
• Change and set tools.
• Make simple machine adjustments to maintain part integrity.
• Operate both powered and non-powered material handling equipment including forklifts, pallet jack, cranes, and mobile straddle stacker lift.
• Report any damage to a supervisor or manager.
• Follow instructions, procedures and to escape any issue impacting workflow, quality, etc.
• Exhibit honesty and integrity and demonstrate adherence to rules, procedures and policies.

To perform this job successfully the candidate must be able to perform each essential duty adequately. The requirements listed below are representative of the knowledge, skill, and/or ability required. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions of this job.

High school diploma or high school equivalency (HSE) credential such as general education degree (GED) is required, plus an additional one to three months related experience, training and/or equivalent combination of education and experience.

Minimum Years Of

Experience:

3-5 years

Must have the ability to read, write, and comprehend simple instructions and safety rules; such as work instructions, short correspondence, and memos in English.

Must have the ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals. May need to compute rate, ratio, and percent and to draw and interpret graphs.

Must have the ability to apply common sense and understanding in order to carry out written, oral, and/or diagram instruction forms. Must be able to deal with problems involving several concrete variables in standardized situations.

Sitting – Occasionally

Standing – Frequently

Walking – Occasionally

Bending (neck) – Frequently

Bending (waist) – Rarely

Squatting – Frequently

Twisting (neck) – Frequently

Twisting (waist) – Frequently

Climbing – Frequently

Kneeling – Frequently

Crawling – Frequently

Reaching (above shoulder level) – Frequently

Reaching (below shoulder level) – Frequently

Repetitive use of hand – Frequently

Simple grasping – Frequently

Power grasping – Frequently

Fine manipulation – Frequently

Pushing & Pulling – Frequently

Close vision – Yes

Distance vision – Yes

Color vision – Yes

Peripheral vision – Yes

Depth perception – Yes

Adjust focus – Yes

0-10 lbs. – Frequently

11-25 lbs. – Frequently

26-50 lbs. – Frequently

51-60 lbs. – Occasionally

61+ lbs. – Occasionally

This position requires computer use, including monitor, keyboard, mouse, trackball, touchpad, etc.

The work environment characteristics described here are representative of those an employee encounters while performing the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions of this job.

Noise Level – Loud

Work Environment:
General office or engineering lab environment – Never

Employee will work around machining or on the production floor – Constantly

Employee is exposed to moving mechanical parts and vibration – Frequently

Employee is exposed to hazardous chemicals, fumes or airborne particles – Occasionally

Employee is exposed to outside weather conditions, extreme cold or extreme heat – Frequently

Employee is exposed to risk of electrical shock – Rarely