Non-Destructive Inspection Technician; NDI III

The Non-Destructive Inspection Technician (NDI) III inspects aerospace weapon systems components and support equipment for structural integrity using nondestructive inspection methods and performs fluid analysis.

• Performs nondestructive inspection on structures, components, and systems.

• Processes parts and performs equipment standardization to carry out any necessary preparation of parts before or after inspection.

• Detects flaws such as cracks, delaminations, voids, processing defects, and heat damage using penetrant, eddy current, magnetic particle, radiographic, optical, and ultrasonic test
  equipment.

• Determines metallurgical information of components according to alloy, temper, conductivity,
  and associated factors.

• Sets up and standardizes equipment, conduct tests, interprets and evaluates for acceptance or
  rejection, and documents.

• Performs operator maintenance and service inspections on shop equipment and tools.

• Performs silver recovery functions.

• Follows written instructions in the techniques/methods for which certified.

• Develops written instructions from approved general procedures.

• Determines test method and technique and prepares fluids and parts for nondestructive inspection.

• Interprets nondestructive inspection test results and provides information about defects to repair center.

• Reviews x-rays.

• Analyzes wear metal content reports on engine lubricating oil and other fluids and recommends corrective action.

• Establishes radiation areas for radiographic operations.

• Computes and monitors personal exposure areas for radiographic operations, and monitors
  personnel exposure data.

• Ensures lock out and tag out procedures are accomplished prior to maintenance on equipment.

• Handles and disposes of hazardous waste and materials.

• Interprets codes, standards, and other contractual documents that control the NDT method(s) as utilized by the employer.

• Prepares and verifies the adequacy of procedures in the method certified.

• Approves NDT procedures and other NDT related work instructions for technical adequacy in the method in which they are certified.

• Provides the necessary guidance and supervision to trainers and Level I and II personnel in the
  technique/method in which they are certified.

• Provides or directs training, examination, and certification of personnel in the method in which they are certified.

• Assumes technical responsibility for the NDT staff.

• Shall be trained and qualified per NAS 410 or ASNT-CP-189.

• Three (3) or more years’ experience as an aviation inspector.

• Familiar with the scope and limitations of the technique/method in which they are certified.

• Familiar with the codes, standards, and other contractual documents that control the methodas utilized by the employer.

• Must be able to pass a Respirator Physical and Fit Test qualification.

• Must be able to obtain and maintain facility credentials/authorization.
  
  Note:
  
  US Citizenship is required for a facility credentials/authorization at the work location.

• Have the skills and knowledge to set up and standardize equipment, conduct tests, interpret and evaluate for acceptance or rejection, and document.

• Thoroughly familiar with the scope and limitations of the technique/method in which they are certified.

• Capable of providing the necessary guidance and supervision to trainers and Level I and II personnel in the technique/method in which they are certified.

• Familiar with the codes, standards, and other contractual documents that control the method as utilized by the employer.

• Capable of developing written instructions from approved general procedures.

• Knowledge of electrical, mechanical, electronic, hydraulic, and pneumatic systems or other technology as applicable to fabrication, repair, operation and maintenance requirements.

• Efficient in record keeping and preparation of reports; capable of reviewing other people's work and determining accuracy and conformity to standards.

• Excellent organizational skills in prioritizing workload to meet aircraft delivery schedule.

• Must be able to walk and stand on level and/or inclined surfaces for extended periods throughout the day.

• Must be able…