Power Supply Test Engineer
Listed on 2026-06-02
-
Engineering
Electrical Engineering, Electronics Engineer
3+ years hands-on testing of high-voltage, high-power AC-DC / DC-DC converters
Strong understanding of PFC, flyback, LLC, or similar topologies
Proficient with oscilloscope, HV differential probes, current probes, power analyzers, electronic loads
Comfortable and safety-conscious working around high-energy DC buses
Hands-on, bench-focused test engineer responsible for high-voltage power supply validation,
design characterization, and DVT execution for new product development programs.
ResponsibilitiesPerform extensive bench-level testing of high-voltage AC-DC and DC-DC power
supplies (300–800+ VDC bus)
Execute Design Characterization (DC) and DVT plans under full power and stress conditions
Validate efficiency, ripple, regulation, transient response, hold-up time, and protection features
Perform loop stability (FRA/Bode) measurements on high-voltage PFC and isolated stages
Conduct high-voltage start-up, inrush, and fault testing
Perform thermal characterization at full load and elevated ambient
Debug board-level and system-level issues in high-energy power circuits
Capture and analyze high-voltage waveforms using differential probes and current probes
Document structured test results with clear pass/fail criteria
#J-18808-Ljbffr(If this job is in fact in your jurisdiction, then you may be using a Proxy or VPN to access this site, and to progress further, you should change your connectivity to another mobile device or PC).