Assembly and Test Technician

Job Title

Assembly and Test Technician

The hourly rate for this position is $22.40 + $1.00 shift differential per hour. The hours for this shift are 3:30 pm - 12:00 am.

Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations.

• Assembles and builds all non‑Marine & Defense sub‑assemblies, rotating group, pumps, and motors having close tolerances and critical operating requirements where fitting, alignment, and adjustment are precise.
• Completes all required quality and customer information on reports and documents.
• Troubleshoot and repair to full operational status, all REO and failed test stand pumps and motors.
• Sets up and/or operates all assembly department test stands without assistance and maintains appropriate requirements. In cases where automated test stands are present, operator may be responsible for the operation of two stands.
• Reads and interprets test procedures to determine if the unit meets all applicable quality and standards requirements. Read gauges as required by the test procedures and transfers applicable/required data to defined quality reports and documents.
• Interpret hydraulic schematics, pressure gauges, strip recorders and test stand "x-y" plots. Must be able to read and interpret assembly and component prints and component maintenance manuals as may be required.
• Responsible for the cleaning and packing operations required for the rotating group processing.
• Utilizes hand tools in building and testing units. Employs measurement instrumentation such micrometers, vernier calipers, etc. to check/verify dimensional assembly requirements as needed.
• Responsible for maintaining cleanliness and order in all working areas maintaining that area to the highest degree of cleanliness required for assembly operations.

Basic (Required)

Qualifications:

• A minimum two (2) years of experience performing complete mechanical assembly, disassembly, and troubleshooting in a manufacturing, military, or aviation environment
  -OR
  - Associate degree in Precision Manufacturing and Machining Technology.
• Must have a high school diploma or GED from an accredited institution.
• Eaton will not consider applicants for employment immigration sponsorship or support for this position. This means that Eaton will not support any CPT, OPT, or STEM OPT plans, F-1 to H-1B, H-1B cap registration, O-1, E-3, TN status, I-485 job portability, etc.
• No relocation benefit is offered for this position. Only candidates residing within the immediate area of Jackson, MS (50 miles) will be considered for this position.
• This position requires access to export‑controlled information. To conform to U.S. Government export regulations applicable to that information, applicant must be a U.S. person, defined as a (i) U.S. citizen or national, (ii) U.S. lawful, permanent resident (green card holder), (iii) refugee under 8 U.S.C. § 1157, or (iv) asylee under 8 U.S.C. § 1158.

• Mechanical Assembly Skills
• Experience in a Manufacturing Environment