Controls Engineer

Controls / automation engineer with PLC + SCADA experience

Comfortable with commissioning and startup

Has worked in industrial environments, ideally water/wastewater

Can work independently

Responsible for programming/configuration, system design, and field execution.

HMI programs

Also, viable

They are open to someone a bit more junior / lower cost if they can:

• Support cutovers
• Do startup work
• Handle QA/QC testing
• Sit in front of a PLC/HMI and validate indications / points / functionality

They could likely use 6-8 total people across the skill sets below, but even 1-2 strong hires immediately would help relieve pressure.

They need some combination of:

• Control Logix programmers
• Modicon / Control Expert programmers
• iFIX resources (likely 1-2 people specifically)

Ignition came up earlier as a harder-to-find / higher-priced skill set, but the immediate needs they specifically called out were the four above.

These people need to be comfortable being hands-on in the field and supporting:

• Startup / commissioning
• Cutovers
• QA/QC validation
• Verifying PLC/HMI points, indications, and functionality
• Helping get wastewater utility systems fully online