Assembler III

Position Summary:

Performs basic and intricate electronic/electro-mechanical assembly functions on prototype and production type hardware according to company workmanship standards and military or client specifications . Assists in the development and wiring of engineering models and in the development of assembly methods and wire lists . Uses hand or power tools to trim, shim, cut, and make other adjustments to fit components together and align them properly.

May assist in instructing and training lower-level assemblers . Reads and interprets wiring lists and assembly drawings to work orders using work instructions . May perform any rework from test failures in accordance with standard repair procedures and may set up and operate automated assembly equipment. At the most senior level may serve as a team leader providing training to new staff and evaluating the performance and finished work of assigned staff.

Essential Duties and Responsibilities include , but are not limited to :

• Determine Detail/Hardware locations per blueprints and mylars
• Set-up and operate Drill Press, Pneumatic drills, “C” squeezes, Hand Squeezes, Rivet Pullers.
• Set up countersinks per fastener requirements and shop router
• Monitor and work with very tight tolerances
• Drill holes in structure and subassemblies, and attaches brackets, hinges, or clips to secure installation or to fasten subassemblies per blueprint and customer specifications.
• Install units, parts, equipment, and components in structural assembly, according to blueprints and specifications, using hand tools and power tools.
• Bolt, screw, or rivet accessories to fasten, support, or hang components and subassemblies.
• Locate and mark reference points and holes for installation of parts and components, using jigs, templates, and measuring instruments.
• Inspects and tests installed units, parts, and equipment for fit, performance, and compliance with standards, using measuring instruments and test equipment.
• Position and align subassemblies in jigs or fixtures, using measuring instruments, following blueprint lines and index points.
• Complete all required training and any additional training required by supervisor.
• Complete quality documentation
• Perform preventative maintenance on assembly presses and tooling
• Verify part and hardware count to shop router
• Other duties as assigned

• 3-4 years of relevant experience
• High school degree or equivalent

• Excellent attention to detail
• Ability to read, understand and interpret engineering drawings and specifications (e.g., blueprint reading, specification, change, design).
• Working knowledge of aircraft manufacturing, instructions and blueprints
• Working knowledge of customer specifications and requirements
• Ability to use calipers, micrometers, etc.
• Mastery of basic math (addition, subtraction, multiplication, division, and fractions)
• Strong teamwork and communication skills to get along with co-workers and be a team player
• Understand and obey safety requirements
• Commitment to keep work area clean and free of debris

• Must be able to lift and/or move up to 50lbs
• Specific vision abilities include close and distance vision, depth perception and ability to adjust focus
• Ability to use hands to finger, handle, or feel, as well as reach with hands and arms for extended periods of time
• Capable of standing for long periods

Supervisory Responsibilities :
None.

Travel Required : N/A

Note :
This job description in no way states or implies that these are the only duties to be performed by the employee(s) of this position . Employees will be required to follow any other job-related instructions and to perform any other job-related duties requested by any person authorized to give…