Cobalt TN Process Engineer

• Lean Six Sigma experience preferred

Department:
Engineering

Reports To:

Department Supervisor

FLSA Status:
Salary

The purpose of this position is to serve as a technical expert for Process Engineering. This position will assist in planning, directing, and coordinating manufacturing process improvement initiatives and support operations in all areas of the manufacturing process.

• Evaluate and solve production problems
• Assist in researching and developing new processes and procedures
• Document and update work instructions, standard operating procedures, and time observations of production processes
• Identify and remove/improve process non-value added elements
• Develop CAD layouts to optimize process and materials flow
• Work with supervisors to solve quality issues
• Participate in Continuous Improvement Events (Kaizen Events, 5S events, etc.)
• Other duties as assigned by Supervisor

To perform this job successfully, an individual must be able to perform each essential duty satisfactorily. The requirements listed below are representative of the knowledge, skill, and/or ability required. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.

• Bachelor’s degree or higher education in industrial engineering, mechanical engineering, or related field
• Marine production experience preferred
• Lean Six Sigma experience preferred

Ability to read and interpret documents such as safety rules, operating and maintenance instructions, and procedure manuals. Ability to write routine reports and correspondence. Ability to speak effectively before groups of customers or employees of organization.

Ability to apply common sense understanding to carry out instructions furnished in written, oral, or diagram form. Ability to deal with problems involving several concrete variables in standardized situations.

CAD experience preferred; proficient in MS office products

The physical demands described here are representative of those that must be met by an employee to successfully perform the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.

• Sits 4 hours
• Stands 5 hours
• Walks 1 hours
• Drives 0 hours

type amount of weight in each area

Maximum: 50 (lbs) Frequently: 10 (lbs) Occasionally: 50 (lbs)

• Simple Grasping:
  Right, Occasional Left, Occasional
• Pushing/Pulling:
  Right, Occasional Left, Occasional
• Fine Manipulation:
  Right, Occasional Left, Occasional

• Right:
  None Left:
  None

• Bending At Waist:
  Occasional
• Squatting:
  Occasional
• Climbing Ladders, Stairs:
  Occasional
• Kneeling On Ground:
  Occasional
• Reaching Above Shoulder:
  Occasional

Work around moving mechanical parts and equipment; vibration; and chemicals.

Typical 10-hour workdays, overtime may be required

To perform the job successfully, an individual should demonstrate the following competencies:

Balances team and individual responsibilities;
Exhibits objectivity and openness to others' views;
Gives and welcomes feedback;
Contributes to building a positive team spirit;
Puts success of team above own interests;
Supports everyone's efforts to succeed.

Measures self against standard of excellence.

Demonstrates accuracy and thoroughness;
Applies feedback to improve performance;
Monitors own work to ensure quality.

Is consistently at work and on time.

Takes responsibility for own actions.