Assembly Worker Structures - F35

Position: Assembly Worker Structures  - F35
*
* Description:

** Lays out and locates structural components or assemblies in making production assemblies as specified by design changes, working from blueprints or other authorized documents  Performs difficult structural pick up and/or rework such as removing, replacing or realigning ribs, bulkheads, stringers, or fittings in completed skinned assemblies, or where a considerable portion of the operation consists of reforming, recontouring or refitting to provide an acceptable assembly  Works structural changes which materially alter previous assembly references and practice  Performs trimming, reforming and altering parts and structures as required  Fabricates detail parts such as shims, splices, gussets, angles, brackets, doublers, stiffeners and patches  Performs portable milling operations on wing and center section attaching joints  Must be able to layout and secure coordination of assemblies working to station, water, center, butt, and chord lines shown on engineering documents

When required, works from blueprints or other authorized documents where complete information is not readily available and/or with inadequate tooling, or without aid of tooling  Works from production, pre  release, check, detail, assembly and installation blueprints, D A T 's sketches or other authorized documents

Lays out and locates structural components or assemblies in making production installations as specified by design changes, working from blueprints or other authorized documents  Performs such final assembly operations as pick up and rework on structures and installations, installing shortages, and bringing up all items to latest engineering changes  In addition, makes corrections of a mechanical nature on plumbing, electrical, controls, and power plant installations  Operates controls for free operation and makes corrective adjustments short of operational check out  Operates landing gear, up locks and down locks, to check for clearance  Completes installation of and fits such items as landing gear doors, flaps, etc  Fits or refits fillets;

lays out and installs fillets as required  Fabricates structural items such as clips, brackets, angles, gussets, supports, etc , required

Improvises shop aids to facilitate assembly and installation as required  Works off sub assembly and final assembly squawks as required  Must be able to layout and secure coordination of assemblies working to station, water, butt, center and chord lines, shown on engineering documents

When required, works from blueprints or other authorized documents where complete information is not readily available and/or with inadequate tooling, or without the aid of tooling  Works from production, pre release, check, detail, assembly and installation blueprints, photographs, charts and diagrams, D A T 's, sketches or other authorized documents

Works with authorized liaison personnel as necessary to determine satisfactory assembly and installation sequence  Points out need for tooling, parts, or assembly corrections

May install power plants and propellers when so assigned

Refers to assembly prints, sketches, specification sheets, planning and other authorized documents to ascertain size, type, and location of rivets and detail components to be assembled  Sets up rivet machine by selecting and installing proper combination drill countersink or punch dimple sets and upper and lower anvils in operating head and bottom post  Selects, installs and fills proper size rivet hoppers

Lays out rivet patterns to scale as required  Recognizes and notifies designated personnel of improper machine functioning  Installs heater blocks and sets specified temperature and dwell time when performing punch hot dimple riveting  Performs rework such as drilling out and replacing defective rivets  Performs satisfactorily any function of the Structures Assembler classification as required

NOTE:

Up to six months of experience may be offset by experience in the following areas:

A&P licensed mechanic

GAhourly

*
* Basic Qualifications:

*
* Two years of aircraft sheet metal assembly  riveted structure and installation of functional and/or electrical components  experience or…