Maintenance Inspector

Maintenance Inspector

Duties include but are not limited to:

• Inspects and makes adjustments and repairs on various types of Building Service Equipment and Systems. Includes: air handling units; pumps; air compressors; generators, elevators, lifts, electric motors and controls; bathroom fixtures, exhaust fans; sump pumps; steam condensate and vacuum pumps; heating equipment; lighting, sprinkler, and medical air and vacuum systems; hydraulic and pneumatic door systems, etc. Inspection duties include all tasks listed in Preventive Maintenance Inspection Standards, Joint Commission regulation, VAMC regulations, Construction Standards, and local building codes.
• Inspects and makes adjustments and repairs on all classes of Personal Property valued at $500 or more that is electrically or mechanically operated. Includes:
  Dietetic, Engineering, and Environmental Management equipment; certain technical medical equipment, etc. Inspection duties include all tasks required by Preventive Maintenance Standards.
• Typical inspection check points on equipment; electrical malfunction, frayed and cracked wire insulation, bad connections, signal lamps, solenoids, thermostats, coils, starters, controllers, push buttons, worn and burnt contacts, brushes, brush holders, dirty and worn commutators, switches, tubes, fuses, fuse clips, loose lugs, transformers, relays pressure switches, excessive vibration, or rough bearing, mechanical failures, dirty filters, alignment of motors, belts, shafts, pulleys, steam leaks, water leaks, air leaks, oil leaks, lubrication, safety valves, gaskets, looseness, warpage, imbalance, rust and corrosion, excessive wear, chains, rollers, fans, valves, etc.
• Performs routine greasing and oiling of all major types of equipment in accordance with VA regulations and manufacturers' recommendations.
• Reports any malfunctions detected in equipment being serviced.
• Assigns inspection schedules and preventive maintenance protocols to all equipment belonging to the Electrical/Electronic Equipment Unit.
• Reviews inspections and protocol requirements on an annual basis.
• All other duties as assigned.

Work Schedule:

Monday-Friday, Multiple Shifts : 0630A.M.

-15:00,P.M., 07:00A.M.

-15:30P.M.. and or 07:30 A.M.

-15:30P.M..

Position Description Title/PD#:
Maintenance Inspector/PD00795A

Physical Requirements:

Must be able to crawl, stoop, climb to heights of approximately 30 feet, bend, lift over 30 lbs., and work in close places where necessary to make adequate inspections.