Form Carpenter

Turner Industries Group is looking for an experienced Form Carpenter for work in the Saint Paul, MN area.

• Must be able to pass background check and drug screen
• Must be able to pass craft test
• NCCER Certified Plus, preferred
• Per diem and relocation are not available for this position

Constructs, erects, installs, fabricates, dismantles and repairs structures, formwork and fixtures of wood, metal forms and associated accessories.

Studies blueprints, sketches or structural plans for information pertaining to the type of material required, such as lumber or fiberboard, and dimensions of structure or fixture to be fabricated; selects specified types of lumber or other materials; prepares layouts including lines and grades; marks cutting and assembly lines on materials; shapes materials to prescribed measurements; assembles cut and shaped materials and fastens them together;

erects framework for structures and lays sub‑flooring; builds stairs and lays out and installs partitions and cabinet work; covers sub‑floor with building paper to keep out moisture and lays hardwood, parquet and wood‑strip block floors; fits and installs prefabricated window frames, doors, door frames, weather stripping, interior and exterior trim, and finish hardware such as locks, letter drops and kick plates;

constructs forms and chutes for pouring concrete; erects scaffolding and ladders for assembling structures below ground, at ground level or above ground level; fabricates from work then loads, hauls, and carries it to the job site and installs per drawings, sketches or plans; places and finishes concrete in formwork and sets and aligns form panels; sets grout forms for epoxy and cement grout.

• One (1) to four (4) years of experience in specified skill (depending on mechanic level)
• Written pre‑employment qualification test
• Post‑offer drug/alcohol screen and physical evaluation
• Hazard Communication orientation/test
• Job site safety requirements as required by the client (clean shaven, long sleeves, steel toe boots, etc.)
• Safety equipment as required by the client (hard hat, safety glasses, gloves, respirator, hearing protection, safety harness with lanyard, etc.)
• Applicant/employee must not pose a direct threat to the health or safety of such individual or others in the work place.

Employee may be required to provide the following: tool box, claw hammer, hand saw, framing square, level, tri square, torpedo level, measuring tape, nail pouch, plumb bob, gloves, nail bar, chalk box, tie wire pliers, hack‑saw, pliers or vise grips, screw drivers, wood chisels, folding ruler or tape, crescent wrench, scaffold socket wrench and combination wrench, rain suit

Employee may be required to do the following: climbing ladders, scaffolds, structures, etc. above and below ground level; maintaining balance on ladders, scaffolds structures, etc.; reaching in all directions, handling and manipulating objects and materials; coordinating the movements of eyes, hands and fingers to operate tools and equipment; lifting 30 to 50 pounds from ground level, waist level, and/or overhead; carrying objects, tools, equipment, etc.;

standing; sitting; walking; pushing; pulling; bending; kneeling; crouching/squatting; crawling; seeing with or without correction; hearing with or without correction

May be required to do the following: follow set procedures and standards; follow oral/or written directions; knowledge of federal, state and company standards and regulations; ability to read and write; ability to recognize and report safety hazards etc.; interpret written plans and blueprints; applying basic mathematical skills; planning work and selecting proper tools; comparing and understanding differences in the size, shape and form of lines, figures and objects;

picturing and evaluating solid objects from drawing or diagrams using standards that can be measured or checked; ability to communicate with others effectively; ability to work in a team and get along with others; ability to learn new tasks; remember processes, maintain focus, and complete…