Field Service Technician

The role will be based out of Corpus Christi, TX, work in the Permian, and travel across the area! Job Summary

We are seeking a highly skilled Field Service Technician to support the installation, commissioning, maintenance, and troubleshooting of oil & gas measurement and automation systems, including LACT units, meter skids, NGL skids, and gas meter runs.

This role requires a strong foundation in electrical, instrumentation, and mechanical systems, along with the ability to diagnose complex field issues, improve system reliability, and deliver high-quality service to customers in demanding field environments.

The ideal candidate thrives in a fast-paced, hands-on environment and is committed to safety, precision measurement, and continuous improvement.

Install, commission, and start up:

• ACT (Lease Automatic Custody Transfer) units
• Crude oil, produced water, and NGL meter skids
• Gas meter runs (orifice, ultrasonic, Coriolis, thermal mass)
• Perform meter proving, calibration, and system validation in accordance with API and AGA standards
• Troubleshoot and repair:
• Flow meters (Coriolis, ultrasonic, turbine, PD)
• Control valves, regulators, and back pressure valves
• Pumps, motors, and mechanical components
• BS&W equipment, sampling systems, and analyzers

• Install, commission, and troubleshoot:
• Electrical systems (up to 480V), MCCs, and control panels
• PLCs, RTUs, flow computers, and HMI systems
• VFDs, transmitters (pressure, temperature, flow, level), and I/O systems

Diagnose faults using:

• Multimeters, megohmmeters, and diagnostic tools
• Electrical schematics, loop diagrams, and P&IDs
• Ensure proper grounding, bonding, and compliance with electrical and safety standards

• Respond to scheduled and emergency service calls across the Permian Basin
• Execute work safely using LOTO, JSAs, permits, and energized work procedures
• Interface directly with customers, providing technical expertise and professional service
• Generate detailed service reports including:
  • Root cause analysis
  • Failure modes
  • Corrective actions and recommendations

• Perform preventative and predictive maintenance to reduce downtime
• Identify recurring failures and drive root cause solution

• Standard work development
• Troubleshooting guides and checklists
• First-time fix rate improvements

• Reducing variation
• Improving uptime
• Enhancing service quality

• 5+ years of field service experience in oil & gas, measurement, or industrial environments

• Industrial electrical systems (480V and below)
• Measurement systems and instrumentation

• P&IDs
• Electrical schematics and loop diagrams

Experience working independently in remote field locations

Valid driver’s license required, with the ability to maintain a clean and safe driving record.

• Experience with LACT units, meter skids, or gas measurement systems
• Flow computer experience (ABB, Emerson ROC & FB3000, OMNI, WAGO, etc.)
• PLC/HMI experience (Allen-Bradley, Siemens, IDEC, Red Lion, Beijer, etc.)
• VFD experience (ABB, Danfoss, Rockwell, Schneider, LS, Benshaw, etc.)
• Familiarity with API and AGA standards
• Certifications:
  
  OSHA 10/30, H2S, Safeland/PEC, Arc Flash, TWIC
• Lean / Six Sigma or reliability experience

• High School Diploma or GED required
• Technical or vocational training in Electrical, Instrumentation, or Industrial Maintenance preferred
• Equivalent field experience or 5–10 years in a similar technical role accepted.

• Frequent travel across the Permian Basin, STX, SE NM. (up to 90-95%)
• Work outdoors in extreme…