RF Designer

Fidus is a global high-tech design firm headquartered in Ottawa, withadditionaldesign centres in Kitchener‑Waterloo and San Jose. We specialize in leading-edge electronic product development, with hardware, RF/wireless, embedded software, FPGA/ASIC, and signal integrity teams working together to design and deliver next-generation products for clients in emerging technology markets.

The RF Designer owns complete RF subsystems on Fidus client programs — from the antenna port through the front-end, frequency conversion and data converters, that present into the DSP and/or FPGA fabric. You will set the RF architecture, build the frequency and sampling plans, design and model the transmit and receive lineups, and prove the performance on the bench, working at microwave frequencies up to 40 GHz.

This role suits an RF designer who has carried subsystems from architecture to characterized, manufacturable hardware, is ready to be the RF authority on a cross‑functional team, and works directly with customers — taking pride in designs rigorously modeled before build and rigorously measured after.

You’ll collaborate across FPGA/DSP, hardware, embedded software, verification, SI/PI, PCB layout and mechanical/thermal design, delivering real products for our clients.

In practice, that means Sat Com payloads, ground modems and portable terminals; GNSS and precision synchronization; radar and multi‑sensor fusion; software defined radios; semiconductor characterization and test fixturing; industrial and private network radios; and medical telemetry.

• Define the RF architecture and frequency plan — IF and LO selection, Nyquist zone/sampling plan, clocking, anti‑alias/spurious filtering, and line‑up specification.
• Design Tx chains from baseband through up‑conversion — drivers, filters, power amplifiers to 10 W, ALC and detector‑based output level control, and output protection.
• Design Rx chains, including digitally intensive sampling architectures — LNA lineups, down‑conversion strategy, analog variable gain and AGC, interferer rejection, and input limiting and protection.
• Model and budget system performance: NF, sensitivity, dynamic range, linearity, EVM, and the LO and clock phase noise and jitter needed to support it.
• Specify and select filters, mixers, circulators, isolators, couplers, dividers and hybrids, including custom parts developed with third‑party vendors.
• Configure the digital signal path — RFSoC hard IP, DUC/DDC, decimation and interpolation filters, sample rate conversion, and FIR synthesis for arbitrary amplitude and phase response.
• Drive RF and microwave PCB layout with our layout and signal integrity teams, designing for compliance from the outset.
• Build‑in the features that make a subsystem manufacturable (e.g., factory calibration hooks, digital correction filters, and register access to enable ATE).
• Verify/characterize performance in the lab using spectrum and signal analyzers, VNAs, vector and analog signal generators, and power meters.
• Develop technical estimates and risk mitigation strategies, and work closely with clients to produce well‑documented, maintainable designs that stand up to review.

• Bachelor’s degree in Electrical Engineering, Computer Engineering, or equivalent. A Master’s in RF/microwave engineering or communications is an asset.
• 8+ years designing RF and wireless hardware
• Familiarity with FDD and TDD techniques
• Experience interacting with FPGA, DSP, PCB Layout, and Signal Integrity designers
• Signal source and clocking design: PLL topology and loop filter design, VCO/DRO and LO multiplier specification, TCXO and VCXO selection, and phase noise and jitter specification and measurement.
• Filter and…