Sheet Metal Ductwork Installer

Sheet Metal Installer Employment Requirements Knowledge and Skills

• Read basic HVAC plans and shop drawings
• Lay out and install rectangular, round, spiral, and flex duct
• Install fittings, dampers, access doors, grilles, registers, and diffusers
• Measure, cut, modify, and assemble sheet metal
• Seal ductwork with approved mastic, tape, and sealant
• Install duct hangers and supports correctly
• Use hand tools, drills, saws, snips, and power tools safely
• Understand basic duct sizes, airflow direction, and system layout
• Work from ladders, scaffolds, and lifts
• Follow OSHA and jobsite safety requirements
• Coordinate with supervisors and other trades
• Perform quality work with minimal supervision
• Keep the work area clean and organized

• Tape measure
• Marker and pencil
• Aviation snips
• Sheet-metal hammer
• Hand seamers
• Crimpers
• Folding bar
• Utility knife
• Cordless drill and impact driver
• Drill bits, nut setters, and driver bits
• Level
• Adjustable wrench and basic hand tools
• Tool pouch or tool bag
• Safety glasses
• Work gloves
• Hard hat
• High-visibility vest or shirt
• Steel-toe or safety-toe work boots

• Valid driver’s license and reliable transportation
• Ability to arrive on time and work a full schedule
• Ability to lift approximately 50 pounds
• Ability to work in hot, confined, and elevated areas
• Legal authorization to work
• Reliable phone and communication
• Willingness to travel to different jobsites
• Ability to pass required background checks or drug testing
• OSHA 10 certification preferred
• Lift certification preferred
• Previous commercial HVAC installation experience preferred