Production Operator - Transfer 2nd Shift

Production Operator - Transfer 2nd Shift

Full Time Technical Plymouth, MN, US

$20.48 To $28.26 Hourly

(Transfer Team)

The Production Operator is responsible for performing a variety of manual, semi-automated or automated tasks necessary for the manufacturing of sub-assemblies and/or final product. The Production Operator is responsible for maintaining productivity, quality, on-time delivery and safety of self and co-workers. This position operates under minimal guidance from management or senior staff. The Production Operator ensures Pro Med’s brand, philosophy, systems, policies, and procedures are properly implemented and observed.

Position duties and responsibilities include, but are not limited to the following:

• Follows manufacturing procedures, including documentation of product traceability;
• Operates the required manufacturing equipment in a safe and efficient manner using designated tools;
• Completes assembly-related tasks like gluing, heat-shrinking, and resistance welding;
• Supports research and development projects, as needed;
• Performs press setups, as required;
• Reads, comprehends and performs duties as outlined in the Standard Operating Procedure (SOP);
• Follows all start up and shut down procedures;
• May provide temporary support to other production teams as business needs demand;
• Meets expectations of regular, reliable attendance;
• Other Duties as Needed:
  Any other duties and tasks as deemed necessary and appropriate.

To perform this job successfully, an individual must be able to perform each essential duty satisfactorily. The requirements listed below are representative of the knowledge, skill, and/or ability required. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.

• High School diploma or equivalent;
• Fine motor skills in hands/wrist and good hand/eye coordination;
• Good vision (with or without corrective lenses);
• Must be able to read, write, speak and comprehend written and verbal instructions in English;
• Ability to stand for extended periods of time;
• Ability to sit for extended periods of time;
• Ability to work independently with minimal supervision;
• Ability to meet deadlines and priorities;

• Experience using a microscope/reticle;
• Experience in thermoplastic or silicone molding and inspection;
• Clean room component or device level manufacturing experience;
• Knowledge of ISO 13485 (current) Standards.