Cold Heading Setup Technician; Precision Fasteners

Compensation & Schedule

• Hourly range: $25–$35/hour
• Hours:
  
  Monday–Friday, 1:30 p.m.–10:30 p.m., with possible overtime

You’ll arrive, review the production plan, and set up your header for the next run—dialing in speeds, pressures, temperatures, feeds, and dimensions. Throughout the shift you’ll monitor gauges and signal lights, check part dimensions with calipers, micrometers, and a Length Gage, and collaborate with the Supervisor to troubleshoot anything that could impact throughput or quality. You’ll clear jams safely, remove nonconforming parts, and apply Root Cause Analysis (RCA) methods to prevent repeat issues.

• Set up and operate cold heading machines (One-Die/Two-Blow to Four-Die/Four-Blow) for fastener production.
• Continuously monitor material flow, machine indicators, and the surrounding environment to detect and assess problems early.
• Gather information from all relevant sources and escalate or resolve issues quickly with the Supervisor.
• Inspect machines, tooling, structures, and materials to pinpoint causes of errors or defects.
• Adjust machine components to regulate speeds, pressures, temperatures, feed rates, dimensions, and material flow.
• Start, stop, and regulate equipment via control panels and push buttons.
• Examine, measure, and weigh parts to verify conformity using calipers, micrometers, and a Length Gage.
• Observe lights, gauges, and machine behavior; clear jams safely; remove defective or substandard parts.
• Use Root Cause Analysis (RCA) techniques to identify true root causes and drive corrective actions.

• 3–7 years of cold heading experience with proven setup capability; fastener industry experience preferred.
• Clear, calm communication with supervisors, peers, and team members—written, verbal, email, and in person.
• Strong prioritization and organization; able to switch between tasks with minimal errors or omissions.
• Working knowledge of IATF 16949 requirements.
• Solid deductive reasoning skills to apply general rules to specific issues.
• Hands‑on ability to fine‑tune machines (speeds, pressures, temperatures, flow, and dimensions).
• Basic heading maintenance knowledge.
• Proficiency with calipers, micrometers, and blueprint reading.
• Commitment to OSHA regulations and all company safety policies.

• Ability to lift up to 40 pounds.
• Must wear Personal Protective Equipment (PPE) which is required in designated areas.
• Ability to continuously stand and move through 8–10‑hour shifts.
• 100% onsite. One work location.

This job description in no way states or implies that these are the only duties to be performed by the employee(s) of this position. Employees will be required to follow any other job-related instructions and to perform any other job-related duties requested by any person authorized to give instructions or assignments. All duties and responsibilities are essential functions and requirements and are subject to possible modification to reasonably accommodate individuals with disabilities.

To perform this job successfully, the employee(s) will possess the skills, aptitudes, and abilities to perform each duty proficiently. Some requirements may exclude individuals who pose a direct threat or significant risk to the health or safety of themselves or others. The requirements listed in this document are the minimum levels of knowledge, skills, or abilities. This document does not create an employment contract, implied or otherwise, other than an at-will relationship.