Manufacturing Engineer

kSARIA Riepilogo posizione

• New product introduction, including device preparation, prototype setup, assembly line preparation, documentation preparation.
• Assembly line transfer.
• RTM smooth & continuous process improvement.
• New manufacturing technology introduction.

• Effectively cooperate with product designer to optimize product design and validation.
• Lead new assembly line build-up according to product requirement by lean thinking.
• Cooperate with quality engineer to deal with Quality Complaint and Customer audit in project early stage.
• Operator training: orientation training and training for new employees.
• New manufacturing technology research and development.
• Be responsible for process documentation preparation and review, such as build report, process flowchart, process map, PFMEA, work instruction, etc.
• Be responsible for sample build.
• Assembly line specific parts concept design, be responsible for new production line running smoothly and into ramp up stage in time.
• Responsible for productivity and capacity improvement, including manpower, line balance and assembly line layout optimization.
• Responsible for assembly line transfer, including device, technology, and documentation.
• Process capability analysis, continuous process improvement and optimization, such as WIP reduction, product failure mode analysis, production yield improvement.

• Bachelor’s degree in mechanical engineering (Required).
• Master’s degree in mechanical design (Preferred).

• 4+ years of work experience as a process engineer (Required).
• Good assembly device debug skill (Required).
• Familiar with mechanical design, assembly process (Required).
• 10+ years of experience (Preferred).
• Familiar with molding, stamping, plating process (Preferred).
• Familiar with automatic control, laser, ultrasonic application (Preferred).
• Familiar with Robot technology, vision experience (Preferred).

• Be familiar with IE tools, such as 5W1H, Poka Yoke, Motion analysis, Line balancing analysis, Combination work analysis, and Kaizen activities, like PDCA cycle, 7 steps, 5S, Standardized Work, ECRS, Process Mapping, etc. (Required).
• Familiar with office software (MS Office, AutoCAD) (Required).
• Basic knowledge in TS 16949 (Required).
• Lean experience (Preferred).
• Familiar with 3D software (Preferred).
• Strong leaning & innovation thinking.
• Good skills of communication and conflict handling.
• Open minded, and self-motivated.
• Excellent oral and written communication skills including English and Italian.